User manual GAGGIA ANIMA

[. . . ] 3 Brewing two products with one button (possible only when using coffee beans) . 4 Adjustment of coffee length in the cup 2 Monthly lubrication of the brewing unit 3 Monthly degreasing of the brew group (one Symbols The following symbols are used in some parts of the booklet: Indicates actions that should on no account be carried out. Indicates actions that require some caution. When using electrical appliances, basic safety precautions should always be followed, including the following: To protect against fire, electric shock and injury to persons do not immerse Close supervision is necessary when the appliance is used by or near Unplug from outlet when not in use and before cleaning. [. . . ] All other components must be washed in lukewarm water. Damages or improper use caused by cleaning and maintenance activities are NOT covered by the warranty. Before cleaning the machine, check that the machine, the grounds and the water in the tank have cooled. These processes must be launched every time the `drip tray full' indicator raises. If the indicator is completely raised, this means that the tray is full: be careful when you remove it. With the machine turned on, empty and clean the coffee grounds drawer and the drip tray. If the machine is turned off, once turned on the `Coffee grounds drawer full' signal is still on. > Remove the coffee grounds drawer and empty it. > Put the coffee grounds drawer in the drip tray and put the latter back into the machine. Further maintenance operations can be carried out only when the machine is turned off and disconnected from the power grid. > Follow the step-by-step instructions in the "7. 1 Machine cleaning when needed" chapter until you reach the seat of the drip tray. The brew group must be cleaned at least once a week. Weekly cleaning of the brew group is a cleaning cycle with water (accurate rinsing). > Turn the machine off with the STAND-BY button. Wait for the STAND-BY button to Place the thumb on the PUSH button and then the other fingers, on the handle. Press the PUSH button and pull the handle. > Clean the coffee outlet duct thoroughly with the appropriate cleaning tool, supplied Together with the machine. > Remove the coffee residues drawer and wash it thoroughly. > Wash the brew group accurately with lukewarm water and clean the upper filter accurately. Do not use detergents or soap to clean the brew group. > Let the brew group air dry completely. [. . . ] Machine setting phase during the replacement > Press the MENU button and scroll the menu to go to the `INTENZA+ Filter function. > If you wish to replace the INTENZA+ water filter with a new INTENZA+ filter, press the DOWN button until the RESET value can be selected. Alternatively, if you wish to remove the INTENZA+ filter without replacing it, select the OFF value. > Press the OK button to confirm the change. [. . . ]