User manual GAGGIA KIII

[. . . ] Push-buttons and their functions 3 - Light steam ready - Light machine on ON/OFF button - Light machine ready Coffee selection button Steam selection button Text contained in this booklet has been accurately checked through. However, should any printing mistakes be found, you are kindly requested to inform the manufacturer. As part of our effort to constantly improve our products, we reserve the right to make any amendments to and update this publication without prior notice. No part of this booklet may be reproduced in any way of form, without the prior permission of the manufacturer All instructions that are important for user safety are marked with the symbol . [. . . ] When the lever is pulled down, the capsule holder and the capsule in it are pushed upwards. During this step, the capsule is pierced from the bottom and from the top by two small spikes to let the water through. The coffee making process starts once the coffee selection button has been pressed; to stop this function press the coffee selection button again. Hot water is pushed through the top hole into the capsule, out of the lower hole and into the cup. Your caffè lungo, cream coffee or espresso is ready to drink. The advantages of using the "CAFFITALY SYSTEM" coffee capsules the capsules of the exclusive "CAFFITALY SYSTEM" offer the following advantages: · Different flavours to choose from · Always ready to use · Quick coffee-making without mess · Each capsule contains the correct amount of coffee for one cup of caffè lungo, cream coffee or espresso coffee. Yon can control the amount of coffee as you like pressing the coffee selection button to start and pressing it again to stop this function. To pre-heat the cup, you simply need to fill the cup with hot water and empty it before use. Once the coffee machine is ON and a capsule is inside the holder, it is advisable not to wait too long before using the capsule so as not to loose the flavour of the coffee. A used capsule should never be left inside the machine. The damp coffee that remains in the capsule after use is bound to mould just like any ground coffee or food stuff. If a used capsule is inadvertently left in the machine for a few days, clean the capsule holder in accordance with the instructions given in this manual and, if necessary, clean the spike inside the capsule-holder support, being careful not to cut yourself. If the machine remains out of use for more than a week, dispense a cup of hot water (as described on Page 9) before using it to make coffee. Remove the cable plug from the power outlet. Put the water tank back in place and close the lid. Turn ON the machine by pressing the ON/OFF switch; when the light () turns on, the machine is ready for use. Note: Some water may dribble out of the capsule holder while the water is being heated. This is perfectly normal and does not jeopardize the operation of the appliance. Draw the capsule holder out of the coffee machine (Fig. Re-introduce the capsule holder into the coffee machine and pull down the lever completely. Place a cup in the middle of the drip tray grating right under the spout of the capsule holder. Once pressed, the coffee is being prepared. [. . . ] notice · Use a commercially available de-scaling fluid that is environmentally-friendly and suitable for automatic coffee machines. To de-scale the machine, carry out the following procedure: . Mix the de-scaling agent with water according to manufacturer's instructions and pour the mix into the machine's water tank. Turn the knob and dispense a cup of hot water. [. . . ]