User manual GAGGIA MAGENTA PLUS

[. . . ] Congratulations on your purchase of Gaggia Magenta!This easy-to-use machine guarantees excellent results every day. Thanks to the intuitive interface, you can choose among 5 beverages and customise them according to your preferences. Before being packed, each of our high-quality machines undergoes rigorous testing in our laboratories in order to ensure its correct operation. [. . . ] Note: the function Pre-ground allows the brewing of just one coffee at a time. 9 Once the beverage has been customised according to your preferences, you can proceed with dispensing it by pressing START/STOP button. Remove the brew group and clean it under running water. See the "Cleaning and lubricating the brew group" chapter. Clean the brew group with the Gaggia coffee oil remover to remove any oily coffee residue When the red mark appears from Empty the drip tray and clean it under running Empty the coffee pucks container and clean it under running water. Ensure that the machine is switched on during this procedure, otherwise the coffee pucks container will not reset. Clean the upper part using the handle of a spoon, as shown below. When to clean Depending on usage How to clean Remove the espresso tray and clean it with running water. You can also dishwash it in the upper tray. 1 Remove the classic pannarello and the rubber handle from the steam tube and rinse them under running water. 2 Clean the steam tube with a damp cloth. 1 Clean the steam wand with a damp cloth. To clean it more thoroughly, you can unscrew the nozzle and wash it with running water. Allowing the steam to escape for one or two seconds to clean the nozzle hole. Cleaning the brew group Warning: do not wash the brew group in the dishwasher and do not use dishwashing detergents, since they may cause the malfunctioning of the brew group and alter the coffee flavour. Removing the brew group 1 Turn off the machine and disconnect the power cord. 2 Remove the drip tray and the coffee pucks container. 4 Press the PUSH lever (1) and pull the handle of the brew group (2) to remove it Cleaning the brew group under running water 1 Clean the coffee outlet duct thoroughly with a spoon handle or with another round-tipped kitchen utensil. 2 Rinse the brew group and the coffee residues drawer thoroughly with lukewarm water. Note: to avoid the build-up of fibres in its interior, do not dry the brew group with cloth. Reinserting the brew group 1 Before placing the brew group back into the machine, make sure that the two yellow reference marks on the side match. If this is not the case, perform the following step: Make sure that the lever is in contact with the base of the brew group. [. . . ] The coffee comes out slowly or in drops. The nozzles of the coffee dispensing spout are blocked. The coffee grinder is set to a too fine grinding. The nozzles of the coffee dispensing spout are blocked. [. . . ]