User manual GAGGIA TS

[. . . ] It also provides important maintenance information, and details on any residual risks, and all those operations which require particular care. The present manual is to be considered as an integral part of the machine and must be CONSERVED FOR FUTURE REFERENCE until the final dismantling of the machine. This instructions booklet must always be available for consultation and must be kept in a protected and dry place. In the event of loss or damage to the same, the user may ask the manufacturer or local dealer for a new manual, indicating the machine model and serial number of the same as indicated on the identification plate. [. . . ] 1) and fill the tank (2) with cold water. It is advisable to use water having a hardness not higher than 10°F to avoid encrustations. 2), paying attention to remove the level control plates (Fig. When re-placing it, remember to re-place the level control plates otherwise the machine would not be enabled to start. Insert the power cable (3) into the machine and the plug into an appropriate outlet (Fig. Before carrying out the connection make sure that the main switch (5) is on pos. Then wait until the machine reaches the operating pressure of "1, 2 - 1, 3 BAR" by checking the boiler pressure on the manometer (Fig. When the machine is new the filter-holder sump may not be aligned (perpendicular to the machine itself) as shown in the figure at the side, however this does not effect the efficient function of the same. After a short period of use the sump will gradually settle into a correct position. A = Position of closed filter-holder with new machine. B = Position of closed filter holder with machine after a short period of use. 8), so that the water can reach the regular level in the boiler. Only during the first loading, this operation can take quite a long time and make the machine stop; in this case switch off the machine and switch it on again by acting on the main switch (Fig. 1mm ) than that fitted as standard are included. These packings may be used in the event of difficulty with insertion of the filter holder. Depending on the quantity of coffee ground, the appropriate filter must be as shown to avoid (Fig. 04) that, once the coffee has dripped out, the leftover powder remains attached to the nozzle. Disconnect group thermostat (2) (Code DM1561 ­ T 103°C) and replace it with the lower temperature thermostat (Code DM1736 ­ T 98°C), included in the machine equipment. Double pod for 2 coffees The filter may be recognised by the letter "C" printed inside 4 spouts are supplied with the machine to dispense one or two coffees. The figure (beside) shows the different distances from the cup-holding tray (H), depending on the different types of spouts fitted on the filter holder. Select the correct filter and place it into the filter holder, use the small filters for one cup and the big filter for two cups (Fig. Then place the filter holder into the machine and wait until it is heated. [. . . ] Below-cup seal replacement Seal (20) needs to be replaced in the event that coffee leakage is noted between unit (21) and filter-holder (16), or in the event that on closing filter holder (16) the unit centre is greatly exceeded. Then proceed to remove seal (20) using a screw driver. After removing the seal undertake to clean the slot and then reassemble the new seal taking care to insert it with the chamfered part turned upwards towards the unit itself. Wait for the machine to reach the correct temperature 3. [. . . ]