User manual GAI-TRONICS 12576-125 ACCESS PANEL WITH VFD

[. . . ] Of the 27 push buttons, 23 contain an LED lamp that can be configured to provide system status information. The four remaining push buttons, including the lower push button to the right of the VFD and the lower three push buttons in the rightmost column of five switches, contain non-functional LEDs. These non-functional LEDs may be used as spares. GAI-Tronics Corporation 400 E. Mohnton, PA 19540 USA 610-777-1374 800-492-1212 Fax: 610-796-5954 VISIT WWW. GAI-TRONICS. COM FOR PRODUCT LITERATURE AND MANUALS Model 12576-125 Access Panel with VFD Pub. [. . . ] Tighten the captive screw in order to clamp the connector lock around the power cord. Plug the other end into a grounded ac electrical outlet. The access panel does not contain an internal power switch. The access panel will power up immediately. Push Button Overlay To install or replace the push button overlay, proceed as follows: 1. Loosen the eight mounting screws located along the edge of the existing push button overlay using a 1/16-inch Allen wrench or equivalent. Lift the existing push button overlay away from the access panel. Mount the new push button overlay onto the access panel, aligning the screw-holes on the overlay with those on the access panel. Replace and tighten the eight mounting screws using a 1/16-inch Allen wrench or equivalent. f:\standard ioms - current release\42004 instr. manuals\42004-636l2b. doc 11/10 Model 12576-125 Access Panel with VFD Pub. 42004-636L2B Page: 6 of 8 Operation Operation of this assembly is highly dependent on the attached system's software configuration. The software is factory-created and subsequently downloaded to the system control unit via an external PC at system start-up. This access panel offers the following standard features in addition to the configurable features. The standard features include a handset used for page and party functions, a vacuum fluorescent display (VFD) used to provide system status in a text format, and a piezo alarm that can be activated to alert a user of a change in system status. Handset Communications The handset is used for both page and party communications. Lifting the handset from the cradle creates an off-hook condition. In a normal configuration, lifting the handset causes it to be connected to a party line. Vacuum Fluorescent Display (VFD) and Control The VFD displays status messages from the system control unit in a text format. Typically, the push buttons to the right of the VFD are configured for NEXT and PREVIOUS functions. Use the NEXT push button to view each additional new message. The NEXT push button can be configured to flash when a new message is available. Use the PREVIOUS to cycle backward in order to review old status messages. Piezo Alarm The piezo alarm is an audible indicator. It is typically configured to sound when a new message is available on the VFD. If configured as described above, press the NEXT push button to display each new message. When the last available new message has been displayed, the piezo alarm turns off. [. . . ] The applicability of any such third-party warranty will be determined by GAI-Tronics. Services. Any services GAI-Tronics provides hereunder, whether directly or through subcontractors, shall be performed in accordance with the standard of care with which such services are normally provided in the industry. If the services fail to meet the applicable industry standard, GAI-Tronics will re-perform such services at no cost to buyer to correct said deficiency to Company's satisfaction provided any and all issues are identified prior to the demobilization of the Contractor's personnel from the work site. Re-performance of services shall be Buyer's sole and exclusive remedy, and in no event shall GAITronics warranty obligations with respect to services exceed 100% of the total cost of the services provided hereunder. Warranty Periods. Every claim by Buyer alleging a defect in the goods and/or services provided hereunder shall be deemed waived unless such claim is made in writing within the applicable warranty periods as set forth above. Provided, however, that if the defect complained of is latent and not discoverable within the above warranty periods, every claim arising on account of such latent defect shall be deemed waived unless it is made in writing within a reasonable time after such latent defect is or should have been discovered by Buyer. Limitations / Exclusions. The warranties herein shall not apply to, and GAI-Tronics shall not be responsible for, any damage to the goods or failure of the services supplied hereunder, to the extent caused by Buyer's neglect, failure to follow operational and maintenance procedures provided with the equipment, or the use of technicians not specifically authorized by GAI-Tronics to maintain or service the equipment. [. . . ]