User manual GAI-TRONICS 12587-102 ICS SUBSET EXTENSION CABLE ASSEMBLY

[. . . ] 42003-231A GAI-TRONICS® CORPORATION A HUBBELL COMPANY ICS Subset Extension Cable Assembly Replacement Kit MODELS 12587-101 & 12587-102 Confidentiality Notice This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive business and technical information that is confidential and proprietary to GAI-Tronics. GAITronics retains all intellectual property and other rights in or to the information contained herein, and such information may only be used in connection with the operation of your GAI-Tronics product or system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party. General Information The Model 12587-101 and 12587-102 ICS Subset Extension Cables allow the ICS remote subset to be positioned up to 100 feet from the remote amplifier. [. . . ] Install the DB25 female connector on the supplied wall plate, using the included two 4-40 jack screws to attach the connector to the wall plate. Figure 1. Install the wall plate using the two mounting screws provided. After all connections have been made, plug the DB25 male connector into the receptacle at the amplifier enclosure. Plug the subset plug into the DB25 wall receptacle. Be sure that the connector housing seats fully into place, and use the DB25 connector thumb screws to secure the connector. f:\standard ioms - current release\42003 kit manuals\42003-231a. doc 04/10 MODELS 12587-101 & -102 ICS SUBSET EXTENSION CABLE ASSEMBLY REPLACEMENT KIT Pub. 42003-231A Page: 3 of 3 Installation as a Subset Extension Cord 1. Arrange the extension cable so that the DB25 male connector is connected at the amplifier enclosure or wall receptacle. Remove the thumb screws from the DB25 female connector. Plug the cable's female DB25 connector into the remote subset cable's (or an additional extension cable's) DB25 male connector and secure the connectors. Additional extension cables may be connected in order to attain the necessary length. The maximum total length of the combined extension cables is 100 feet. When a cable is of sufficient length to reach the subset has been assembled, connect the female DB25 connector at the end of the cable to the receptacle on the remote subset. Figure 2. Installation as a Subset Extension f:\standard ioms - current release\42003 kit manuals\42003-231a. doc 04/10 Warranty Equipment. GAI-Tronics warrants for a period of one (1) year from the date of shipment, that any GAI-Tronics equipment supplied hereunder shall be free of defects in material and workmanship, shall comply with the then-current product specifications and product literature, and if applicable, shall be fit for the purpose specified in the agreed-upon quotation or proposal document. If (a) Seller's goods prove to be defective in workmanship and/or material under normal and proper usage, or unfit for the purpose specified and agreed upon, and (b) Buyer's claim is made within the warranty period set forth above, Buyer may return such goods to GAI-Tronics' nearest depot repair facility, freight prepaid, at which time they will be repaired or replaced, at Seller's option, without charge to Buyer. Repair or replacement shall be Buyer's sole and exclusive remedy. The warranty period on any repaired or replacement equipment shall be the greater of the ninety (90) day repair warranty or one (1) year from the date the original equipment was shipped. [. . . ] If the equipment is under warranty, repairs or a replacement will be made in accordance with the warranty policy set forth above. Please include a written explanation of all defects to assist our technicians in their troubleshooting efforts. Call 800-492-1212 (inside the USA) or 610-777-1374 (outside the USA) for help identifying the Regional Service Center closest to you. (Rev. [. . . ]