User manual GAI-TRONICS DEX-102

[. . . ] Pub. : 42004-679L2D GAI-TRONICS® CORPORATION A HUBBELL COMPANY Model DEX-101, -102, -201, and -202 Hazardous Area Driller's Intercom Stations TABLE OF CONTENTS Confidentiality Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Product Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 System Requirements and Limitations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Features and Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Available Models. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Maximum System Cable Lengths Digital Models Cable Capacitance 22 AWG 20 AWG Analog Models 22 AWG 20 AWG 30. 5 nf/1000 feet 13. 7 nf/1000 feet 6562 feet 9843 feet 6562 feet 9843 feet 4921 feet 6562 feet 2. Install the speaker cable on TB1 Speaker terminals LS1 and LS2. Refer to Table 2 for recommended conductor sizes. Install the beacon control cable on TB1 terminals C1 and C2. This control output is available on digital stations only. Refer to Table 2 for recommended conductor sizes. Install the footswitch cable on TB1 terminals N. O. Refer to Table 2 for recommended conductor sizes. After all connections are made, inspect and clean the machined and threaded surfaces of both the termination cover and box. Clean the surfaces by wiping with a clean, lint-free cloth. Apply a light coat of Killark LUBG lubricant to the cover threads. Install and hand-tighten the cover to the box. f:\standard ioms - current release\42004 instr. manuals\42004-679l2d. doc 10/10 MODEL DEX-10X AND DEX-20X DRILLER'S INTERCOM STATIONS Pub. : 42004-679L2D Page 9 of 13 System Interconnection Refer to Figure 6 for a typical system wiring diagram. Consult the Central Switch manual for further details on equipment connections to the central switch. Figure 6. Typical system interconnection diagram f:\standard ioms - current release\42004 instr. manuals\42004-679l2d. doc 10/10 MODEL DEX-10X AND DEX-20X DRILLER'S INTERCOM STATIONS Pub. : 42004-679L2D Page 10 of 13 Operation The Driller's Intercom stations can be operated in hands-free, switched-duplex mode when the conditions permit. If the conditions are not acceptable, the user can switch to simplex mode by depressing the T button. In some situations (example: high ambient noise levels or stations in close proximity), the station must be operated in simplex mode at all times. Digital Models DEX-102 and DEX-202 Intercom Communication Modes Master Communication - Communication between two stations can be automatically enabled during the system start-up, or enabled/disabled by the master station. To enable communication depress 6T and the number of the radio channel. Refer to the "Listening to the Radio Channel" section of the Central Switch manual for more details. NOTE: The associated slave station must be configured to transmit to the radio channel. The LED on the front panel illuminates to indicate a call is in progress. [. . . ] Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21/27 V dc range Power consumed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 watts (nominal) 50 watts (maximum) Construction finish. . . . . . . . . . . . . . Gray powder epoxy/polyester on exterior surfaces Front panel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]