User manual GAMUT PHI7

[. . . ] Your Phi´s comes with a pair of GamuT "stretch to fit" mounting gloves. Use these gloves or take off your rings and watches to avoid scratching the delicate surfaces. All Phi are fully assembled and tested at the factory, so no parts needs mounting. [. . . ] This results in a listening angle of app. 20 degrees off axis to the listener, in an optimum listening setup. Why toe-in: The maximum tweeter level is on axis. The more off axis you listen the lower the high frequency level will be in the listening position. Use toe-in to adjust/increase the high frequency level, and to reduce the high frequencies being reflected off the side walls. Hold the speaker in its vertical position with one hand, and use your other hand to tighten all 4 knobs as hard as you can by hand. The special geometric design of the feet will now use gravity and friction to lock the adjusting knob when sufficient force is on the foot. If you need to tilt the speaker front/back or sideways, push the speaker to its desired position and again tighten all 4 knobs. You may need to adjust the tilt of the speaker to fit your seating height. Single wire connection: Connect the positive cable to one of the red terminals, and the negative wire to the black terminal. Bi-wire connection: Unscrew all 4 nuts from the terminals and remove the two brackets. Connect one pair of cables to the lower input, positive to red (right hand side), negative to the black terminal, and one pair to the upper pair of terminals. Speakers are Electro-mechanical devices. They need a run-in period to reach their optimum performance level. We suggest letting the speakers run at high Levels for at least 6 hours before judging the sound quality. The process of running in can take up to 200 hours of music playing at high levels, and agening of the materials as well will also play an important role in reaching the maximum performance. [. . . ] A good choice is to keep the connections clean by using a clean cloth & spirit. The knobs on the terminals will over time loosen as the cable gives in to the pressure from the knob, tighten the connections in between. Keep the looks Clean the lacquered and cloth surfaces using a clean damp cloth with a light detergent or a soft brush. Be careful not to deform the diaphragms of the drive units while cleaning. [. . . ]