User manual GARDENA WT 1030

[. . . ] 9. Where to Use Your GARDENA Water Timer . 5 Putting Your Water Timer into Operation . 12 Putting Your Water Timer Out of Operation . Function Battery : For functional safety reasons, only use a 9 V alkali-manganese (alkaline) battery type IEC 6LR61. [. . . ] Pay attention to the polarity P (+/ ­ markings). Re-attach the control unit 2 to the housing. Make sure you exchange the battery at the right time to prevent the Water Timer failing due to a low battery when you are away for longer periods of time. 2 from 5 4 1 2 6 3 6 P z Make sure that the time the battery has been in operation and the time you are planning to be away does not add up to more than a year. 7 G Installing the anti-theft protection (optional) : G To protect your Water Timer against theft, the GARDENA AntiTheft Protection Art. 1815-00. 791. 00 is available from the GARDENA Service. Fasten the bracket 7 to the back of the Water Timer using the screw 8. The bracket can be used to attach a chain, for example. The screw cannot be loosened once it has been screwed in. Set the time on the inner light-grey scale by turning the control knob and confirm the time you have selected by pressing the OK button (e. g. : 10:00 am). 8 2. The Start Time LED flashes. 7 5. Operation Setting the watering program : The Water Timer control unit 2 can be removed. This allows you to set the watering program somewhere other than where the Water Timer is to be used. The time of day and watering starting time are entered to the nearest hour. Turn the control knob to OFF and confirm by pressing the OK button. The program stored in the memory is overwritten. Setting the watering starting time : 3. Set the watering starting time on the inner light-grey scale by turning the control knob and confirm the time you have selected by pressing the OK button (e. g. : 20:00). 3. The Frequency LED flashes. Setting the Watering Cycle : 4. Set the watering cycle on the outer grey scale (Frequency Hours / Days) using the control knob and confirm your selection by press-ing the OK button (e. g. : 12 hour cycle). 1. 8 The Time LED flashes. 4. The Run Time LED flashes. 9 G Setting the Watering Time : 5. Set the watering time on the outer black scale (Run Time Minutes) using the control knob and confirm your selection by pressing the OK button (e. g. : 30 minutes). G Manual watering (ON) : On especially hot days the programmed watering cycle is sometimes insufficient. You can then turn on your sprinkler or irrigation system manually. The program you have set remains unchanged. The valve opens for 30 minutes independent of the set program. To activate the set program again, you must reset the watering time to the time originally set. 5. The program you have selected is now active. Bad-weather function (OFF) : Changing the watering time : On hot or cooler days you can change the watering time before the program starts without having to re-enter the time of day, watering starting time or watering cycle. Select the changed watering time on the outer black scale (Run Time Minutes) by turning the control knob. [. . . ] : EU directives : Water Timer electronic WT 1030 1825 Electromagnetic Compatibility 89 / 336 / EC Directive 93 / 68 / EC 2001 Ulm, 20. 07. 2001 Year of CE marking : Thomas Heinl Technical Dept. Szymanów 9 d 05 - 532 Baniocha Portugal MARKT (Portugal), Lda. GARDENA Algueirão 2725-596 Mem Martins Russia / . cc 66 117330 c 74 75 Singapore Variware Holland Road Shopping Centre 227-A 1st Fl. , Unit 29 Holland Avenue Singapore 1027 Slowenia / Croatia Silk d. o. o. [. . . ]