User manual GARMIN AIS 600 INSTRUCTIONS

[. . . ] Use these instructions to program and install the Garmin® AIS 600 marine Automatic Identification System (AIS) Class B transponder device. Compare the contents of this package with the packing list on the box. If any pieces are missing, contact your Garmin dealer immediately. When navigating, carefully compare information provided by the unit to all available navigation sources, including information from visual sightings, local waterway rules and restrictions, and maps. [. . . ] Ensure that the large rubber gasket is in place on the bottom of the GA 30 bracket antenna, place the antenna on the surface-mount bracket , and twist the antenna clockwise to lock it in place . Surface-mounting the GA 30 Antenna 8. Secure the antenna to the mounting bracket with the included M3 set screw . Route the cable away from sources of electronic interference, and connect it to the AIS 600 using the BNC connector. Mounting surface 6 AIS 600 Instructions Pole-mounting the GA 30 Antenna With the pole-mount adapter attached to the GA 30 antenna, you can install the antenna on a standard 1 in. OD (14 threads per inch) pipethreaded-pole marine mount (not included). You can run the cable through the pole or outside the pole. to mount the GA 30 with the cable run outside the pole: 1. Route the cable through the pole-mount adapter, and place the cable in the vertical slot along the base of the pole-mount adapter. Thread the pole-mount adapter onto a standard 1 in. OD (14 threads per inch) pipe-threaded-pole marine mount (not included). Place the GA 30 antenna on the pole-mount adapter and twist the antenna clockwise to lock it in place . Secure the antenna to the adapter with the included M3 set screw . (Optional) With the GA 30 installed on the pole mount, fill the remaining gap in the vertical cable slot with a marine sealant. Attach the marine pole mount to the boat if it is not already attached. Route the cable away from sources of electronic interference, and connect it to the AIS 600 using the BNC connector. to mount the GA 30 with the cable run through the pole: 1. OD (14 threads per inch) pipe-threaded-pole marine mount (not included) in the preferred location, and mark the approximate center of the pole. (19 mm) hole for the cable to pass through. Fasten the pole marine mount to the boat. Thread the pole-mount adapter onto the pole. Route the cable through the pole and connect it to the GA 30 antenna. Place the GA 30 antenna on the pole-mount adapter and twist the antenna clockwise to lock it in place . Secure the antenna to the adapter with the included M3 set screw . GA 0 antenna Pole-mount adapter Vertical cable slot 8. (Optional) With the GA 30 installed on the pole mount, fill the vertical cable slot with a marine sealant. Route the cable away from sources of electronic interference, and connect it to the AIS 600 using the BNC connector. Connecting a VHF Antenna to the AIS 600 To transmit and receive AIS information, the AIS 600 must be connected to a VHF antenna (not included). [. . . ] IN NO EVENT SHALL GARMIN BE LIABLE FOR ANY INCIDENTAL, SPECIAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, WHETHER RESULTING FROM THE USE, MISUSE, OR INABILITY TO USE THIS PRODUCT OR FROM DEFECTS IN THE PRODUCT. SOME STATES DO NOT ALLOW THE EXCLUSION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU. Garmin retains the exclusive right to repair or replace the unit or software or offer a full refund of the purchase price at its sole discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY. [. . . ]