User manual GARMIN DASHCAM 10

[. . . ] 1 Insert a memory card into the slot on the device. ?2 Press it in until it clicks. ? Turning Off the Device Manually NOTE: When the device is connected to an ignition-switched power outlet, it turns off automatically when you turn off the vehicle. ?The device turns off. ? Connecting the Device to Vehicle Power Before you can use or turn on the device, you must install a memory card. ?You can power and charge the device using vehicle power. ? [. . . ] Date Format: Sets the format for the date stamp. ?Time Format: Sets the format for the time stamp. ?Text Language: Sets all on-screen text to the selected language. ?GPSStatus: Displays GPSsatellite information. ?File Flicker Suppression: Sets the refresh rate for recorded video to 50Hz or 60Hz. ?File Delete: Deletes video recordings or photos (Deleting Videos or Photos). ?Format Memory Card: Formats the memory card and deletes all files on the memory card. ?Restore Default Settings: Restores all settings to the factory default values. ?About: Displays device information, including the unit ID and software version. ? Calibrating the Event Detection Sensor After you install the device, you must calibrate the event detection sensor. ?1 Select > Event Detection > G Sensor Reset > OK. ?NOTE: If the device does not detect events or incorrectly detects events after you calibrate the sensor, you can adjust the sensitivity of the sensor (Adjusting the Sensitivity of the Event Detection Sensor). ? Safety Camera Alerts Safety camera alerts are available only for product models with GPS. ?As you approach a safety camera, the device plays an audible alert and displays a warning icon, your current speed, and the speed limit, if available. ? Adjusting the Sensitivity of the Event Detection Sensor You can adjust the sensitivity of the event detection sensor if it does not detect events or incorrectly detects events during normal driving. ?1 Select > Event Detection > G Sensor Sensitivity > OK. ?2 Select the level of sensitivity, and select OK. ? Device Settings NOTICE Deleted or overwritten files cannot be restored. ?Recording Mode: Sets the resolution of video recordings. ?Event Detection: Calibrates the event detection sensor (Calibrating the Event Detection Sensor) and sets and audible alert to sound when the device detects a possible collision event. ?Protected Video Overwrite: Allows protected video recordings to be overwritten by new recordings (Protecting a Video Recording). ?TIP: Overwritten video recordings cannot be restored. ?You should enable this setting only if you do not want to save any protected video recordings. ?Audio Record: Records audio from the built-in microphone. ?Exposure Value: Sets the exposure level (Adjusting the Exposure). ?Screen Brightness: Sets the screen brightness (Adjusting the Screen Brightness). ? [. . . ] A picture of your device connected to a computer appears on the device screen. ?Depending on your computer operating system, the device appears as either a removable drive or a removable volume. ? Changing the Fuse in the Vehicle Power Cable NOTICE When replacing the fuse, do not lose any of the small pieces and make sure they are put back in the proper position. ?The vehicle power cable does not work unless it is assembled correctly. ?If your device does not charge in your vehicle, you may need to replace the fuse located at the tip of the vehicle adapter. ? [. . . ]