User manual GARMIN FORERUNNER 910XT

[. . . ] Forerunner 910XT ® owner’s manual September 2013 190-01371-00_0D Printed in Taiwan © 2011–2013 Garmin Ltd. or its subsidiaries All rights reserved. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. [. . . ] 1 Select MODE > Settings > Run Settings > Foot Pod > Calibration Factor. • Increase the calibration factor if your distance is too low. • Decrease the calibration factor if your distance is too high. Calibrating Your Foot Pod by GPS You must have GPS signals to calibrate the foot pod using GPS. ANT+ Sensors  25 Bike Sensors Your Forerunner is compatible with the GSC 10 speed and cadence bike sensor. For a list of third-party ANT+ sensors that are compatible with the Forerunner, go to www. garmin. com/intosports. GSC 10: one for cadence and one for speed. For information about cadence alerts, see page 9. Training with a Bike Sensor Non-Zero Averaging for Cadence Data Before you start training, you must be in bike sport mode, and you must pair the GSC 10 with your Forerunner. 1 Select MODE > Settings > Bike Settings > bike name > ANT+Spd/ Cad. 2 Select Yes in the Bike sensors present field. 3 If necessary, select More to select the sensor type. The non-zero data-averaging setting is available if you are training with an optional cadence sensor. The default setting is to include zero values that occur when you are not pedaling. To turn the non-zero averaging on or off, select MODE > Settings > Bike Settings > Data Averaging > Cadence. Power Meters About the GSC 10 Cadence data from the GSC 10 is always recorded. If there is no GSC 10 paired, GPS data is used to calculate the speed and distance. Cadence is your rate of pedaling or “spinning” measured by the number of revolutions of the crank arm per minute (rpm). There are two sensors on the 26 For a list of third-party ANT+ sensors that are compatible with the Forerunner, go to www. garmin. com/intosports. Calibrating Your Power Meter Before you can calibrate your power meter, it must be properly installed and actively recording data. You must be in bike sport mode. ANT+ Sensors For calibration instructions specific to your power meter, refer to the manufacturer’s instructions. 1 Select MODE > Settings > Bike Settings > bike name > ANT+Power. 2 Select Yes in the Power meter present field. 4 Keep your power meter active by pedaling until the message appears. • Select Watts to view and edit the zones in watts. Non-Zero Averaging for Power Data The non-zero data-averaging setting is available if you are training with an optional power meter. The default setting is to include zero values that occur when you are not pedaling. To turn the non-zero averaging on or off, select MODE > Settings > Bike Settings > Data Averaging > Power. Setting Your Power Zones Before you configure power zones, you must be in bike sport mode. You can set seven custom power zones (1=lowest, 7=highest). If you know your functional threshold power (FTP) value, you can enter it and allow the Forerunner to calculate your power zones automatically. 1 Select MODE > Settings > Bike Settings > bike name > Power Zones. [. . . ] 2 While holding MODE, turn the device on. 3 Select Yes. 1 Hold MODE and ENTER, and then hold . 2 Release , and then release MODE and ENTER. 1 Take your device out of parking garages and away from tall buildings When the device memory is full, your oldest data is overwritten. [. . . ]