User manual GARMIN G1000 DIAMOND COCKPIT REFERENCE GUIDE DA42VERSION0370.13ORLATER

[. . . ] G1000 TM Cockpit Reference Guide for the Diamond DA42 Copyright © 2004, 2005 Garmin Ltd. This manual reflects the operation of System Software version 0370. 13 or later for the DA42. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] Press the ENT key to accept the new waypoint. Press the FMS knob to remove the flashing cursor. 8. 1 USER DEFINED WAYPOINTS 4. 5. 6. Create User Waypoints from the Navigation Map Page 1. With the Navigation Map Page displayed, push the joystick to activate the panning function. The target pointer is displayed at the present aircraft position. After placing the pointer at the desired position, press the ENT key. The User Waypoint Information Page is now displayed with the captured position. Turn the FMS knobs to select a waypoint name. Press the ENT key to accept the selected name. The first reference waypoint field is highlighted. If desired, turn the FMS knobs to enter the identifier of the reference waypoint and the radial and distance to the reference waypoint. Press the FMS knob to remove the flashing cursor. 2. Figure 8-1 User WPT Information Page Select the User WPT Information Page 1. Turn the large FMS knob to select the NRST page group. Turn the small FMS knob to select the fifth rectangular page icon. With the User Waypoint Information Page displayed, press the FMS knob to activate the cursor. Turn the FMS knobs to enter a name for the new waypoint and press the ENT key. The message `Are you sure you want to create the new user waypoint' is displayed. With `YES' highlighted, press the ENT key. 5. 2. 6. Garmin G1000 Cockpit Reference Guide for the DA42 8-1 SECTION 8 ­ FLIGHT PLANNING Modify a User Waypoint 1. With the User Waypoint Information Page displayed, press the FMS knob to activate the cursor. Turn the large FMS knob to move the cursor to the desired field and turn the small FMS knob to make changes. Press the ENT key to accept the changes. Press the FMS knob to remove the flashing cursor. [. . . ] ARSPC NEAR ­ Airspace near and Special use airspace is near and ahead of the aircraft position. ARSPC NEAR ­ Airspace near ­ less Special use airspace is within 2 nm of the aircraft position. LEG UNSMOOTH ­ Flight plan leg will The approaching flight plan waypoints are too close to allow for smooth turns. Prepare for steep turns ahead and expect noticeable course deviations. [. . . ]