User manual GARMIN G1000 DIAMOND PILOTS GUIDE DA40 DA40F0396.10ORLATER

[. . . ] Diamond DA40/40F Copyright © 2006 Garmin Ltd. This manual reflects the operation of System Software version 396. 10 or later for the Diamond DA40 or DA40F. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] 4) Press the ENT Key to load the frequency into the COM frequency standby field. OR: 1) With the Nearest ARTCC Page displayed, press the MENU Key. 2) Select the option `Select FSS Window' and press the ENT Key. The cursor is placed in the `NEAREST FSS window. 3) Turn the small FMS Knob to select the desired nearest FSS. 4) Turn the large FMS Knob to select the desired FSS frequency. 5) Press the ENT Key to load the FSS frequency into the COM frequency standby field. Selecting a nearest weather frequency: 1) With the Nearest Frequencies Page displayed, press the WX Softkey to highlight the frequency in the `WX FREQUENCY' field. 2) Turn the FMS Knob to select the desired weather frequency. The selected weather frequency is placed in the COM standby frequency box. 4) Press the FMS Knob to remove the flashing cursor. OR: 1) With the Nearest ARTCC Page displayed, press the MENU Key. 2) Select the option `Select WX Window' and press the ENT Key. The cursor is placed in the `NEAREST WX window. 3) Turn the FMS Knob to select the desired nearest WX frequency. 4) Press the ENT Key to load the WX frequency into the COM frequency standby field. 5) Press the FMS Knob to remove the flashing cursor. 190-00592-01 Rev. A Garmin G1000 Pilot's Guide for the Diamond DA40/40F 5-61 GPS NAVIGATION 5. 16 NEAREST AIRSPACES The G1000 alerts the pilot to as many as nine controlled or special use airspaces (three at the most at one time) near or in the flight path. The airspace name, class, controlling agency, vertical limits and associated frequencies are displayed for the selected airspace. Softkeys and page menu options can be used to switch between the lists in the `Airspace Alerts' Box and the `Frequencies' Box. The ALERTS Softkey is always displayed; if pressed, the `Airspace Alerts' Box is selected for scrolling. Airspace Alerts Note: At most, three airspace alerts are shown at any given time Airspace Type and Controlling Agency The Ceiling and Floor Altitudes (vertical limits) Associated Frequencies for the currently selected Airspace Alert Figure 5-60 Nearest Airspaces Window Selecting and viewing an Airspace Alert with its associated information: 1) Select the Nearest Airspace Page (the seventh page in the Nearest (NRST) Page Group). 2) Press the ALERTS Softkey to place the cursor in the `Airspace Alerts' Box (Figure 5-60). 4) Press the FMS Knob to remove the flashing cursor. 5-62 Garmin G1000 Pilot's Guide for the Diamond DA40/40F 190-00592-01 Rev. A GPS NAVIGATION OR: 1) With the Nearest Airspace Page displayed, press the MENU Key. 2) Highlight `Select Alerts Window'. The cursor is placed in the `Airspace Alerts' Box. 5) Press the FMS Knob to remove the flashing cursor. [. . . ] This is often the case in mountainous regions. TIS information is collected during a single radar sweep. Collected information is then sent through the Mode S uplink on the next radar sweep. Because of this, the surveillance information is approximately five seconds old. TIS ground station tracking software uses prediction algorithms to compensate for this delay. [. . . ]