User manual GARMIN G1000: CESSNA 350/400 COCKPIT REFERENCE GUIDE (0530.04 OR LATER) REV. B, OCT, 2007

[. . . ] Integrated Flight Deck Cockpit Reference Guide Cessna 350/400 SYSTEM OVERVIEW FLIGHT INSTRUMENTS ENGINE INDICATION SYSTEM NAV/COM/TRANSPONDER AUDIO PANEL AUTOMATIC FLIGHT CONTROL NAVIGATION FLIGHT PLANNING PROCEDURES HAZARD AVOIDANCE ABNORMAL OPERATIONS ANNUNCIATIONS & ALERTS INDEX Copyright © 2006, 2007 Garmin Ltd. This manual reflects the operation of System Software version 0530. 04 or later for the Cessna 400 and System Software version 0545. 00 or later for the Cessna 350. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] 2) Turn the large FMS Knob to place the cursor in the desired selection field. 3) Turn the small FMS Knob to begin selecting the desired identifier, location, etc. 5) The cursor is now flashing on `ACTIVATE?'. If no altitude constraint or course is desired, press the ENT Key to activate. To enter an altitude contraint, proceed to step 6. 6) Turn the large FMS Knob to place the cursor over the `VNV' altitude field. 7) Turn the small FMS Knob to enter the desired VNV altitude. The option to select `MSL' or `AGL' is now displayed. 9) Turn the small FMS Knob to select `MSL' or `AGL'. The cursor is placed in the `VNV' offset distance field. 11) Turn the small FMS Knob to enter the desired target altitude offset from the selected Direct-to. 12) Press the ENT Key to highlight `Activate?' or turn the large FMS Knob to highlight the `COURSE' field. 13) Turn the small FMS Knob to enter the desired course to the waypoint. 14) Press the ENT Key to highlight `ACTIVATE?'. 15) Press the ENT again to activate the Direct-to. Figure 7-8 Flight Plan Waypoint List (PFD) Select a Direct-to Destination to a Flight Plan Waypoint 1) While navigating an active flight plan, press the Direct-to ( ) Key. 2) Turn the small FMS Knob to the left to display a list of flight plan waypoints as shown in Figure 7-8. 3) Turn the large FMS Knob to select the desired waypoint. The cursor is now displayed on `ACTIVATE?'. 5) Press ENT again to activate a Direct-to. Select a Direct-to Destination to a Nearest Airport 1) Press the Direct-to ( ) Key. Initially, a flight plan waypoint list is displayed as in Figure 7-8. The list is only populated when navigating a flight plan. Figure 7-9 Nearest Airport List (PFD) 7-4 Garmin G1000 Cockpit Reference Guide for the Cessna 350/400 190-00567-01 Rev. B SECTION 7 ­ NAVIGATION 3) Turn the small FMS Knob to the right to display the `NRST' airports to the aircraft's current position as shown in Figure 7-9. [. . . ] The current vertical waypoint can not be reached within the maximum flight path angle and vertical speed constraints. The system will automatically transition to the next vertical waypoint. The lateral flight plan contains a procedure turn, vector, or other unsupported leg type prior to the active vertical waypoint. This will prevent vertical guidance to the active vertical waypoint. [. . . ]