User manual GARMIN G1000-QUEST KODIAK COCKPIT REFERENCE GUIDE

[. . . ] Integrated Flight Deck Cockpit Reference Guide Quest Kodiak 100 Copyright © 2007 Garmin Ltd. This manual reflects the operation of System Software version 0552. 00 or later for the Quest Kodiak 100. Some differences in operation may be observed when comparing the information in this manual to earlier or later software versions. Garmin International, Inc. , 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. [. . . ] A 4) 8-2 Garmin G1000 Cockpit Reference Guide for the Quest Kodiak 100 SECTION 8 ­ FLIGHT PLANNING 8. 4 1) ACTIVATE A FLIGHT PLAN LEG From the Active Flight Plan Page, press the FMS Knob to activate the cursor and turn the large FMS Knob to highlight the desired destination waypoint. Press the ACT LEG Softkey (using MFD only). OR Press the MENU Key, select the `Activate Leg' option from the page menu and press the ENT Key. This step must be used when activating a leg from the PFD. With `Activate' highlighted, press the ENT Key. 3) Figure 8-5 Activate Flight Plan Leg Confirmation the flight plan. This will not delete the stored flight plan, only the active flight plan. 2) 3) Figure 8-7 Delete Flight Plan Confirmation 8. 6 1) 2) INVERT ACTIVE FLIGHT PLAN From the Active Flight Plan Page, press the MENU Key to display the Page Menu. Turn the large FMS Knob to highlight `Invert Flight Plan' and press the ENT Key. The original flight plan remains intact in its flight plan catalog storage location. With `OK' highlighted, press the ENT Key to invert the flight plan. 4) 8. 5 1) 2) STOP NAVIGATING A FLIGHT PLAN Press the FPL Key to display the Active Flight Plan Page. Press the MENU Key to display the Page Menu window. Figure 8-8 Invert Flight Plan Figure 8-9 Invert Flight Plan Confirmation Figure 8-6 Delete Flight Plan 3) Turn the large FMS Knob to highlight `Delete Flight Plan' and press the ENT Key. With `OK' highlighted, press the ENT Key to deactivate Garmin G1000 Cockpit Reference Guide for the Quest Kodiak 100 8-3 190-00645-00 Rev. A SECTION 8 ­ FLIGHT PLANNING 8. 7 CREATE A NEW FLIGHT PLAN Catalog Page. The new flight plan is now in the list. Create a New Flight Plan Using the MFD 1) 2) Press the FPL Key and turn the small FMS Knob to display the Flight Plan Catalog Page. Press the NEW Softkey to display a blank flight plan page for the first empty storage location. Create a New Flight Plan Using the PFD NOTE: A flight plan cannot be entered using the PFD if another flight plan is active. NOTE: After the first leg is entered (using the PFD only), it is immediately activated. 1) 2) Press the FPL Key, then press the FMS Knob to activate the cursor. Turn the small FMS Knob to enter the first letter of the destination waypoint identifier. Turn the large FMS Knob to the right to move the cursor to the next character position. Repeat step 2 to spell out the rest of the waypoint identifier. Press the ENT Key and the cursor is now ready for entering of the next flight plan waypoint. Repeat steps 2 through 4 to enter the identifier for each additional flight plan waypoint. Once all waypoints have been entered, press the FMS Knob remove the cursor. [. . . ] The system notifies the pilot to select auto-sequence mode. Press the OBS Softkey to deactivate the OBS mode. The system notifies the pilot to load the approach frequency for the appropriate NAV receiver. Select the correct frequency for the approach. [. . . ]