User manual GARMIN GET 10 ENGINE TILT ADAPTER INSTALLATION AND CONFIGURATION INSTRUCTIONS

[. . . ] A Printed in Taiwan Determining an Installation Location When you are selecting a location to install the GET 10 adapter, consider the following: · During installation, you connect the GET 10 adapter to the analog gauge (or directly to the engine-tilt sensor), and to the NMEA 2000 network. Therefore: Choose a location that is within 173 in. (4. 4 m) of the analog gauge (or the engine-tilt sensor) to avoid splicing bare wires. Choose a location between the NMEA 2000 backbone and the analog gauge (or the engine-tilt sensor). [. . . ] From the NMEA 2000 Devices list, select the GET 10 device. Select an option: · For most Garmin chartplotters, select Review > Engine Tilt Calibration. · For other Garmin marine devices, select Config > Engine Tilt Calibration. Follow the on-screen instructions to calibrate the engine tilt. Select OK when the calibration is complete. Configuring the Engine Number If your boat has multiple engines, you can indicate which engine each GET 10 adapter is associated with. 1. From the NMEA 2000 Devices list, select the GET 10 device. Select an option: · For most Garmin chartplotters, select Review > Engine Number. · For other Garmin marine devices, select Config > Engine Number. Select the number of the engine that the adapter is associated with. Select Done. GET10InstallationandConfigurationInstructions Troubleshooting the Gauge Type When connected to a gauge, the GET 10 adapter gauge type is set to auto Detect by default, and the adapter automatically detects the type of gauge it is connected to. If the engine-tilt reading on a connected Garmin chartplotter or marine instrument changes with the engine RPM, the adapter may be detecting the wrong type of gauge. To test the gauge-type setting: 1. When the boat is not moving, put the engine in neutral. Use the throttle to increase the engine RPM. If the engine-tilt reading changes with the engine RPM, change the gauge type. From the NMEA 2000 Devices list, select the GET 10 device. Select an option: · For most Garmin chartplotters, select Review > Gauge Type. · For other Garmin marine devices, select Config > Gauge Type. Select an option: · To automatically detect the gauge type, select Auto Detect. · To indicate a one-coil gauge, select 1 Coil. · To indicate a two-coil gauge, select 2 Coil. Perform the gauge-type setting test. Configuring the GET 10 Adapter if the Engine Tilt Calibration, Engine Number, and Gauge Type Selections Are Not Displayed Depending on the version of software loaded on your Garmin marine instrument, the specific configuration options may not be displayed on the configuration screens. To calibrate the engine tilt if the menu option is not displayed: To use the GET 10 adapter, you must calibrate the tilt of the engine that the adapter is associated with. 1. Turn the boat ignition key to the On position (not Start). [. . . ] (24. 7 × 17. 0 × 78. 6 mm) total Cable Length: 16 ft. (4. 9 m) Case Material: Thermoplastic rubber (PCB overmold); PVC jacket (cable); PVC overmold (connectors/strain reliefs). temperature Range: From 5°F to 158°F (from -15°C to 70°C) Compass Safe Distance: 2 in. These trademarks may not be used without the express permission of Garmin. [. . . ]