User manual GARMIN GMR 606 XHD OPEN ARRAY AND PEDESTAL INSTALLATION INSTRUCTIONS

[. . . ] GMRTM 600/1200 Series Radar Installation Instructions Properly install your GMR 600/1200 series radar according to the following instructions. If you experience difficulty installing the chartplotter, seek the assistance of a professional installer, or contact Garmin® Product Support. Before installing your GMR 600/1200 series radar, confirm that the package contains the items listed on the box. If any parts are missing, contact your Garmin dealer immediately. WarnInG: Always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding. [. . . ] From the Radar page, press the Setup softkey to open the setup page. From the Setup page, using the ROCKER, select the Advanced tab. Highlight the Front of Boat Offset slider, and press ENTER. The preview window changes as you adjust the slider. After an offset is determined, press ENTER to save, and press QUIT to return to the Radar page. bow Front of boat Offset = 180° GMR 600/100 Series Installation Instructions stern 7 Front of Boat Offset = 0° Installing the Field-Installable RJ-45 Network Connector (Optional) O-Ring RJ-45 modular plug Ethernet cable termination opper tape strip (not shown) C Preparing the Network Cable A field-installable RJ-45 network connector is provided for you to create a network cable that is the correct length for your installation. 1. Cleanly cut your Ethernet cable to the desired length. Retain the cut RJ-45 connector for Step 4. Remove the strain-relief nut from the cable-connection housing and slide it onto the cut end of the cable as shown. Feed the cut cable end through the connection housing as shown. Cut end of cable Strain relief Connection housing 4. Examine the RJ-45 connector removed in Step 1 and compare it to the wire positions in the table below. Note which cable side, A or B, was removed in Step 1. Position 1 2 3 4 5 6 7 8 Wire Color--Main/Stripe Side A White/Orange Orange White/Green Blue White/Blue Green White/Brown Brown Side B White/Green Green White/Orange Blue White/Blue Orange White/Brown Brown Position 8 Position 1 nOTe: The Garmin Marine Network requires cross-over cables not exceeding 100 meters between devices. When constructing a custom cable from bulk wire, you must create both a Side A and Side B. 5. Prepare the cable for plug installation: · Using a sharp knife, insert the blade between the cable shield and jacket. Slit the jacket 5/8" back from the trimmed end of the cable. (1 mm) · Peel the jacket back and remove the slit portion. · TrimtheshieldandMylarfilmawayfromwires. Becarefulnottocutanyofthewires. · Fold the drain wire back over the jacket and trim to approximately 9/16 in. · Untwist the wire pairs enough to ensure a proper connection. Drain · Arrangeindividualwiresinproperorderaccordingtothetableshownabove. Forexample, ifyouhaveidentified wire the end of the cable in Step 4 as Side A, arrange the wires for Side A. If you are constructing a custom cable from bulk wire, you need to make both a Side A and a Side B connection. · Trim the wire ends to an even length, leaving approximately 9/16 in. (14 mm) from the ends to the jacket edge. [. . . ] This warranty is provided by the local in-country distributor and this distributor provides local service for your unit. Distributor warranties are only valid in the area of intended distribution. Units purchased in the United States or Canada must be returned to the Garmin service center in the United Kingdom, the United States, Canada, or Taiwan for service. 1200 East 151st Street, Olathe, Kansas 66062, USA Tel. [. . . ]