User manual GARMIN GPS 75

[. . . ] GPS 75 Personal Navigator TM OWNER'S MANUAL (Software Version 2. 20 or above) © 1992-1993 GARMIN, 9875 Widmer Road, Lenexa, KS Printed in Taiwan. 66215, USA All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, for any purpose without the express written permission of GARMIN. Information in this document is subject to change without notice. GARMIN reserves the right to change or improve their products and to make changes in the content without obligation to notify any person or organization of such changes or improvements. October, 1993 190-00046-00 Rev. [. . . ] This page displays the waypoint names including bearing and range from present position. You can scroll through the waypoints listed by using the arrow keys. · Move the cursor to the desired waypoint name with the arrow keys. 5. 2PROXIMITY WAYPOINTS The Proximity Waypoint Page allows you to define an alarm circle around a waypoint. This feature is useful in defining an area around a rock, reef, or restricted waters. When you approach one of these waypoints, the GPS 75 will notify you with an alarm tone and the message, "Prox Alarm-[waypoint name], " if you enter the alarm circle. The GPS 75 allows you to define a maximum of nine proximity waypoints. Scroll through the proximity waypoint list using the arrow keys. 5-1 To set a proximity waypoint. . . · Select the Proximity Waypoint Page with the PROX softkey. · Select a blank waypoint name field with the arrow keys. (NOTE: If neither the waypoint name nor the location exists in memory, the Waypoint Definition Page will be displayed. You must then enter the waypoint location. See Section 3. 4 to create a waypoint. ) · Press ENT. · Enter the proximity alarm distance. · Press ENT to enable proximity alarm. If the newly created proximity alarm circle overlaps with an existing proximity alarm circle, you will be informed of the overlap with the message "Proximity Overlap". As long as the overlap remains, this message will be displayed each time the GPS 75 is turned on. (WARNING: If you enter the overlap area, the unit will only inform you of the nearest waypoint. ) 5. 3REFERENCE WAYPOINTS In section 3. 4, we discussed creation of waypoints by entering the latitude and longitude position. Another way to create a waypoint is by referencing an existing waypoint. By indicating the bearing and range from a reference waypoint, the GPS 75 is able to compute a latitude and longitude location for the new waypoint. To create a waypoint referencing another. . . by · Select the Waypoint Definition Page with the WPT softkey. · Highlight the WPT name field and enter the new waypoint name. [. . . ] · Replace the batteries, observing the polarity diagram engraved in the plastic. · Slide the sleeve over the cage until it snaps into place, taking care that you do not tear the gaskets which seal the battery pack. C. 6 MAINTENANCE The GPS 75 is constructed of high quality material and should not require user maintenance. Please refer any repairs to an authorized GARMIN service center. [. . . ]