User manual GARMIN GPS 89

[. . . ] Select "COM Configuration" on the Setup 1 Page, located in the AUX Page Group. The flashing cursor will highlight the Channel Spacing field. Turn the large right knob to navigate from one frequency to the next. [. . . ] Turn the small right knob to the desired frequency. Press the small right knob when finished. On units configured for remote Com frequency recall, pressing the remote recall switch will load the next preset Com frequency into the unit's Standby frequency box and the unit will then display a temporary pop-up window with the current Preset number. The remote recall switch can be pressed multiple times to scroll the entire preset frequency list through the Standby frequency box (the list will "wrap" from the bottom of the list back up to the top, skipping any empty preset positions). The standby frequency isn't activated until a Com flip flop switch (either remote- or bezel-mounted) is pressed. © 2008 GARMIN Corporation GARMIN International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, U. S. A. 913/397. 8200 or 800/800. 1020 Fax 913/397. 8282 Garmin AT, Inc. 2345 Turner Rd. , S. E. , Salem, Oregon 97302, U. S. A. Press the small right knob again to stop highlighting the field. Winds Aloft are represented by meteorological symbols known as "wind barbs. " A wind barb consists of an arrow-like line that indicates the direction in which the wind is blowing, with marks ("barbs") along one side of the line to indicate wind speed. The barbed end of the symbol points in the direction from which the wind is coming. Barbs, which are used singly and in combinations, have the following values: · A short line: 5 knots · A long line: 10 knots · A pennant (triangle): 50 knots To view XM Weather Winds Aloft: while viewing the XM Weather page, verify "WINDS" is displayed in the upper left corner. If "WINDS" is not displayed, press the small right knob to highlight the displayed field and then turn the small right knob to change the field to "WINDS". Press the small right knob again to stop highlighting the field. To change the altitude for Winds Aloft: Turn the large right knob to move the cursor down to the Altitude field, then use the small right knob to select an altitude from ground level up to 42, 000 feet (in 3, 000-foot increments). TAWS - units equipped with TAWS have been enhanced with software v3. 00. These enhancements reduce the amount of TAWS nuisance alerts but do not change the operating characteristics to the pilot in any significant manner. [. . . ] TAWS - units equipped with TAWS have been enhanced with software v3. 00. These enhancements reduce the amount of TAWS nuisance alerts but do not change the operating characteristics to the pilot in any significant manner. The following Forward Looking Terrain Alerting Caution and Warnings should be adhered to when displayed: Cell Movement (CELL MOVE) shows the storm cells identified by the groundbased system. [. . . ]