User manual GARMIN GPSMAP 5208

[. . . ] GPSMAP® 5000 Series owner's manual © 2007 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 East 151st Street, Olathe, Kansas 66062, USA Tel. (913) 397. 8200 or (800) 800. 1020 Fax (913) 397. 8282 Garmin (Europe) Ltd. [. . . ] · · · -- Sounds an alarm for all fish sizes. -- Sounds an alarm for medium and large fish only. -- Sounds an alarm for large fish only. NOTE: You must have an optional sonar module and a transducer connected via NMEA 0183 or the Garmin Marine Network to receive sonar information. Setting Weather Alarms To set a weather alarm from the Home screen, touch Configure > Alarms > Weather. Turn the following alarms on or off: · · · · · Marine Tornado Severe Storm Flood Flash Flood NOTE: You must have a subscription to XM WX Weather and a GDL 30/30A connected via the Garmin Marine Network to view weather information. Refer to page 52 for more information. confIGurInG the unIt Configuring My Boat To configure settings for your boat from the Home screen, touch Configure > My Boat. Auto Guidance--sets the Auto Guidance parameters for your boat: · safe Depth--sets the minimum depth (refers to the chart depth datum) to allow when calculating an auto guidance path. · safe Height--sets the minimum height (refers to the chart height datum) of a bridge that your boat can safely travel under. GPSMAP 5000 Series Owner's Manual confIGurInG the unIt Keel Offset--offsets the surface reading for the depth of a keel. This makes it possible to measure depth from the bottom of your keel instead of from the transducer's location. Enter a positive number to offset for a keel. You can enter a negative number to compensate for a large vessel that may draw several feet of water. 1. FromtheHomescreen, touchConfigure>My Boat>Keel Offset. Usethetouchscreenkeyboardtospecifytheoffset. NOTE: Touch Cancel to cancel your changes and return to the My Boat screen. Transducer at Surface Enter a (+) positive number to show depth from the bottom of the keel. To adjust the Keel Offset: Transducer at Bottom of Keel Enter a (-) negative number to show depth from the surface. Keel Offset confIGurInG unIt the Transducer--sets the temperature source, select sonar cone angles, and calibrate water speed. · sonar Cone Angles--sets the angle, in degrees, of the sonar cone so that it is accurately depicted on the Fish Eye 3D screen when using a transducer other than the standard Garmin transducer. Touch either 200kHz or 50kHz and use the touch screen keyboard to enter the angle. NOTE: The Sonar Cone Angles setting does not affect a standard Garmin transducer, and should only be used to match the specifications of a non-standard transducer. · Temperature source--sets the temperature source (Transducer or NMEA). · Calibrate Water speed--calibrates a speed sensing transducer. Follow the onscreen directions for calibration. If you do not have a speed sensing transducer, this menu does not appear. NOTE: If the boat is not moving fast enough or the speed sensor is not registering a speed, a "speed Too low" message appears. Touch OK and safely increase boat speed. If you get the message again, stop the boat and make sure the speed sensor wheel is not stuck. If the wheel turns freely, check the cable connections. [. . . ] EXCEPT AS EXPRESSLY PROVIDED HEREIN, WE MAKE NO WARRANTY OR REPRESENTATION, EITHER EXPRESS OR IMPLIED, REGARDING THE RADIO SERVICE. YOUR USE OF THE SERVICE IS AT YOUR SOLE RISK. THE CONTENT AND FUNCTIONALITY OF THE SERVICE IS PROVIDED "AS IS" WITHOUT ANY WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. ALL SUCH WARRANTIES OR REPRESENTATIONS (INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE AND NON-INFRINGEMENT) ARE HEREBY DISCLAIMED. [. . . ]