User manual GARMIN GSC10

[. . . ] Install the GSC10 Sensor Place the GSC10 on the rear chain stay (the side opposite of the drive train). Loosely attach the GSC10 using two cable ties. GSC10 on rear chain stay Install the Pedal Magnet Attach the pedal magnet to the crank arm using the adhesive mount and a cable tie. [. . . ] Press Reset again if you require additional passes. When everything is aligned and working correctly, tighten the cable ties, sensor arm, and spoke magnet. GSC10 pedal magnet sensor arm indication line For more information on using the GSC10 with your compatible GPS device, refer to your owner's manual. Configure Your GPS Device To activate the GSC10 accessory: 1. For example, on the EdgeTM 305, select Settings > System > Accessories. In the Cadence Sensor field, select Yes. Make sure there are no other sensors Examples: Edge 305 around you. For the Edge 305, select Settings > Bike Profile. Note: To set up custom data fields on your GPS device to display cadence data, refer to your owner's manual. May 2006 190-00646-00 Rev. C Printed in Taiwan GSC10 TM speed and cadence sensor Sensor Pairing What is pairing?Pairing is the process of matching sensors, like your GSC10, with your compatible GPS device. This process occurs automatically when you turn on your GPS device and only takes a few seconds when the sensors are on and functioning correctly. Once paired, your GPS device will only receive data from your sensor. Pairing tips: · Position your GPS device within 3 meters of the sensor while pairing. · Stay far away from any other sensors while pairing. · Restart scan if your GPS device appears to be paired with another sensor. [. . . ] Use a coin to twist the cover back into place (arrow points battery to locked). cover Note: Dispose of used battery properly. arrow locked unlocked [. . . ]