User manual GARMIN GST 10 WATER SPEED AND TEMPERATURE ADAPTER INSTALLATION AND CONFIGURATION INSTRUCTIONS

[. . . ] notiCe: When drilling or cutting, always check the opposite side of the drilling or cutting surface. Needed Tools and Supplies · Cable ties · Additional NMEA 2000 cabling and connectors (optional) July 2009 190-01081-07 Rev. A Printed in Taiwan Determining an Installation Location When you are selecting a location to install the GST 10 adapter, consider the following: · During installation, you connect the GST 10 adapter to the compatible sensor and to the NMEA 2000 network, and to the NMEA 2000 network. Choose a location that is within 173 in. You cannot extend the cable connecting the GST 10 adapter to the sensor. [. . . ] Select an option: · For most Garmin chartplotters, select Review > N2K Temp. · For other Garmin marine devices, select Config > N2K Temp. Select the location of the temperature sensor. Configuring the Temperature Offset If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same as temperature data displayed on other devices, you can configure the temperature offset to increase or decrease the displayed temperature by a specific amount. 1. From the NMEA 2000 Devices list, select the GST 10 device. Select an option: · For most Garmin chartplotters, select Review > Temperature Offset. · For other Garmin marine devices, select Config > Temperature Offset. Select the temperature offset as a positive or negative decimal number, in degrees. Select Done. Troubleshooting the Sensor Number If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source, each adapter is assigned a unique sensor number automatically. If the "Invalid NMEA 2000 temperature configuration" error message appears, you must assign a unique sensor number to each adapter. For example, if two adapters are assigned the NMEA 2000 temperature source value of Live Well and the error message appears, you must assign each adapter a unique number. 1. From the NMEA 2000 Devices list, select the GST 10 device. Select an option: · For most Garmin chartplotters, select Review > Sensor Number. · For other Garmin marine devices, select Config > Sensor Number. Select OK. GST10InstallationandConfigurationInstructions Configuring the GST 10 Adapter if the Water Speed, Location, Temperature Offset, and Sensor Number Selections Are Not Displayed Depending on the version of software loaded on your Garmin marine instrument, the specific configuration options may not be displayed on the configuration screens. To calibrate the water speed if the menu option is not displayed: To use the GST 10 adapter, you must calibrate the water speed. 1. From the NMEA 2000 Devices list, select the GST 10 device. Select an option: · For most Garmin chartplotters, select Review > Generic Config. · For other Garmin marine devices, select Config >Generic Configuration. Ensure that the boat is stationary; the engine should be off or idling. Enter the following command: WATERSPEED=0Done" 5. Accelerate the boat to cruising speed and observe the maximum speed, in miles per hour. Bring the boat to a stop; the engine should be off or idling. Enter the following command: WATERSPEED=" After the command, enter a positive decimal number that indicates the maximum cruising speed in miles per hour, followed by Done. [. . . ] (24. 7 x 17. 0 x 78. 6 mm) total Cable Length: 16 ft. Garmin®, and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. These trademarks may not be used without the express permission of Garmin. [. . . ]