User manual GARMIN GTM 11

[. . . ] Garmin reserves the right to change or improve its products and to make changes in the content without obligation to notify any person or organization of such changes or improvements. Visit the Garmin Web site (www. garmin. com) for current updates and supplemental information concerning the use and operation of this and other Garmin products. Garmin® is a registered trademark and GTMTM is a trademark of Garmin Ltd. or its subsidiaries and may not be used without the express permission of Garmin. NOTE: Refer to your GPS device's owner's manual or product information sheet to view the warranty, as well as warnings and cautions, FCC compliance information, and the software license agreement. April 2006 Part Number 190-00641-00 Rev. [. . . ] You might have to wiggle it a bit to properly get it to click. To remove the antenna from the GTM 11, press the antenna connector's tab. Pull the antenna off the GTM 11. 2 GTM 11 Owner's Manual TESTING AND MOUNTING THE GTM 11 TESTING THE GTM 11 Use the following testing and troubleshooting techniques: Observe the LED on the GTM 11: Service reception is indicated by the green solid light, which can take up to five minutes to appear for initial data acquisition. Yellow dot-dash flashes: determining which country you are currently in. Yellow solid light: searching table for active entry or scanning for new TMC FM stations Red solid light: momentary sync loss. Check the Map: Check the map on the GPS device for traffic incidents. Refer to the owner's manual to learn how to access the map page. Verify Signal Strength: The traffic information list on the GPS device shows a signal strength indicator in the upper-right corner. Refer to the owner's manual to learn how to access the information list. Verify that you are in a service area: Check for service from the pay service or free services, if available. To view service areas, go to the Garmin Web site at http://www. garmin. com/fmtraffic. Verify that the paid subscription is activated: If the GTM 11 is using a pay service, verify that the subscription has been activated in the Garmin GPS device. Refer to the GPS device's owner's manual to learn how to add subscriptions to the GPS device. GTM 11 Owner's Manual MOUNTING THE GTM 11 After you have connected and tested the GTM 11, you can mount it using the hook-and-loop fastener or the permanent adhesive. For best signal reception, mount the GTM 11 on the A-pillar, which is the area between the windscreen and the door. If possible, mount the GTM 11 so you can see the LED. To mount the GTM 11 with the permanent adhesive: 1. Clean and dry a section of the A-pillar or other suitable mounting surface. Firmly press the adhesive on the back of the GTM 11. Attach the adhesive here. 3. Firmly press the GTM 11 to the mounting surface. NOTE: When mounted, the adhesive is extremely difficult to remove. 3 TESTING AND MOUNTING THE GTM 11 To mount the GTM 11 with the hook-and-loop fastener: 1. Clean and dry a section of the A-pillar or other suitable mounting surface. Remove the backing from the back of the loop material. [. . . ] You may not modify, copy, scan, or use any other method to reproduce, duplicate, republish, transmit, or distribute in any way any portion of traffic incident data. You agree to indemnify, defend, and hold harmless the Traffic Service Provider (and its affiliates) and Garmin Ltd. (and its subsidiaries) against any and all claims, damages, costs, or other expenses that arise directly or indirectly out of (a) your unauthorized use of the traffic incident data or the RDS/TMC network, (b) your violation of this End User Subscriber Agreement and/or (c) any unauthorized or unlawful activities by you in connection herewith. The Traffic Service Data is informational only. [. . . ]