User manual GARMIN GTX 327

[. . . ] You agree not to decompile, disassemble, modify, reverse assemble, reverse engineer or reduce to human readable form the Software or any part thereof or create any derivative works based on the Software. You agree not to export or re-export the Software to any country in violation of the export control laws of the United States of America. October 2002 Part Number 190-00187-00 Rev. B Printed in USA Limited Warranty This GARMIN product is warranted to be free from defects in materials or workmanship for one year from the date of purchase. Within this period, GARMIN will at its sole option, repair or replace any components that fail in normal use. [. . . ] Pushing one of these keys begins the code selection sequence. The new code is not activated until the fourth digit is entered. Pressing the CLR key moves the cursor back to the previous digit. Pressing the CLR key when the cursor is on the first digit of the code, or pressing the CRSR key during code entry, removes the cursor and cancels data entry, restoring the previous code. You may press the CLR key up to five seconds after code entry is complete to return the cursor to the fourth digit. The numbers 8 and 9 are not used for code entry, only for entering a Count Down time, contrast and display brightness, and data selection in the Configuration Mode. Important Codes: 1200 7000 7500 7600 7700 7777 The VFR code for any altitude in the US (Refer to ICAO standards elsewhere) The VFR code commonly used in Europe (Refer to ICAO standards) Hijack code (Aircraft is subject to unlawful interference) Loss of communications Emergency Military interceptor operations (Never squawk this code) 0000 Military use (Not enterable) Avoid selecting code 7500 and all codes in the 7600-7777 range. These codes trigger special indicators in automated facilities. An aircraft's transponder code is used for ATC tracking purposes, therefore exercise care when making routine code changes. Keys for Other GTX 327 Functions IDENT Pressing the IDENT key activates the Special Position Identification (SPI) Pulse for 18 seconds, identifying your transponder return from others on the air traffic controller's screen. The word `IDENT' will appear in the upper left corner of the display while the IDENT mode is active. VFR Sets the transponder code to the pre-programmed VFR code selected in Configuration Mode (this is set to 1200 at the factory). Pressing the VFR key again restores the previous identification code. FUNC Changes the page shown on the right side of the display. Display includes Pressure Altitude, Flight Time, Count Up and Count Down timers. In Configuration Mode, steps through the configuration pages. START/STOP Starts and stops the Count Up, Count Down and Flight timers. In Configuration Mode, steps through configuration pages in reverse. CRSR Initiates starting time entry for the Count Down timer and cancels transponder code entry. Selects changeable fields in Configuration Mode. CLR Resets the Count Up, Count Down and Flight timers. Cancels the previous keypress during code selection and Count Down entry. Returns cursor to the fourth code digit within five seconds after entry. 8 Reduces Contrast and Display Brightness when the respective fields are displayed and enters the number eight into the Count Down timer. [. . . ] Press the FUNC key until `COUNT UP' is displayed. If necessary, press CLR to reset the Count Up timer to zero. Press START/STOP again to pause the timer. Press CLR to reset the timer to zero. To operate the Count Down timer: 1. [. . . ]