User manual GARMIN GTX 328 TRANSPONDER PILOT'S GUIDE

[. . . ] You agree not to export or re-export the Software to any country in violation of the export control laws of the United States of America. CAUTION: The GTX 328 should be turned off before starting or shutting down aircraft engine(s). NOTE: Contact a Garmin dealer for software updates. January 2007 Part Number 190-00420-03 Rev. A Printed in USA Limited Warranty This Garmin product is warranted to be free from defects in materials or workmanship for two years from the date of purchase. Within this period, Garmin will at its sole option, repair or replace any components that fail in normal use. [. . . ] The word `IDENT' will appear in the upper left corner of the display while the IDENT mode is active. VFR Sets the transponder code to the pre-programmed VFR code selected in Configuration Mode (this is set to 7000 at the factory). Pressing the VFR Key again restores the previous identification code. If the VFR Key is disabled (dependent upon installation configuration) a `VFR Key Disabled' message appears, to indicate that no operation took place. FUNC Changes the page shown on the right side of the display. Display data includes Pressure Altitude, Flight Time, Altitude Monitor, Count Up and Count Down timers. Also displays Outside Air Temperature, Density Altitude, Contrast, and Display (dependent upon installation configuration). START/STOP Starts and stops the Altitude Monitor, Count Up, Count Down and Flight timers. CRSR Initiates starting time entry for the Count Down timer and cancels transponder code entry. CLR Resets the Count Up, Count Down and Flight timers. Cancels the previous keypress during code selection and Count Down entry. Returns cursor to the fourth code digit within five seconds after entry. 8 Reduces Contrast and Display Brightness when the respective fields are displayed (dependent upon installation configuration) and enters the number eight into the Count Down timer. 9 Increases Contrast and Display Brightness when the respective fields are displayed (dependent upon installation configuration) and enters the number nine into the Count Down timer. Function Display PRESSURE ALT: Displays the altitude data supplied to the GTX 328 in feet, hundreds of feet (i. e. , flight level), or meters, (dependent upon installation configuration. FLIGHT TIME: Timer start is configured as either Manual or Automatic. When Manual, displays the Flight Time, controlled by the START/STOP and CLR keys. When Automatic, the timer begins when take off is sensed. ALTITUDE MONITOR: Controlled by START/STOP Key. Activates a voice alarm and warning annunciator when altitude limit is exceeded. OAT/DALT: Displayed when the GTX 328 is configured with temperature input. Displays Outside Air Temperature and Density Altitude. COUNT UP TIMER: Controlled by START/STOP and CLR keys. [. . . ] When FLT ID entry is complete the transponder begins normal operation. If an error is made while entering a FLT ID, press the CLR Key to back up to any point, including highlighting the "OK?" field. If an incorrect FLT ID is discovered after the unit begins operation, turn the GTX 328 off. Then turn it back on again and reenter the correct FLT ID. Audio Alerts (Setting options; male/female voice or tone, and volume level. ) · "Leaving Altitude" Altitude deviation is exceeded. [. . . ]