User manual GARMIN USB DATA CARD PROGRAMMER

[. . . ] USB Data Card Programmer user's manual and installation guide © Copyright 2001-2002 Garmin Ltd. or its subsidiaries Garmin International, Inc. 1200 E 151st Street, Olathe, Kansas 66062 U. S. A. Unit 5, The Quadrangle, Abbey Park Industrial Estate, Romsey, SO51 9DL U. K. [. . . ] SOME STATES/COUNTRIES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. RESTRICTED RIGHTS: If this Product is acquired by or for the U. S. Government, then it is provided with Restricted Rights. Use, duplication, or disclosure by the U. S. Government is subject to restrictions as set forth in subparagraphs (c)(1)(ii) of The Rights in Technical Data and Computer Software clause at DFARS 252. 227-7013, or subparagraphs (c)(1) and (2) of the Commercial Computer Software - Restricted Rights at 48 CFR 52. 227-19, or clause 18-52-227-86 (d) of the NASA Supplement to the FAR, as applicable. The contractor/manufacturer is Garmin International, Inc. 7. ) EXPORT CONTROLS: You agree not to export or re-export the Product to any country in violation of the export control laws of the United States of America. GENERAL: This License is the entire agreement between us, superseding any other agreement or discussions, oral or written, and may not be changed except by a signed agreement. This License shall be governed by and construed in accordance with the laws of the State of Kansas, United States of America. If any provision of this License is declared by a court of competent jurisdiction to be invalid, illegal, or unenforceable, such a provision shall be severed from the License and the other provisions shall remain in full force and effect. iii Introduction Features Mini Data Card Programmer Garmin Data Cards The USB Data Card Programmer utilizes Garmin Data Cards. Available in five sizes: 8 MB Data Card 16 MB Data Card 32 MB Data Card 64 MB Data Card 128 MB Data Card Check the Garmin web site or see your Garmin dealer for availability of these data cards. USB Connector 6 Ft. USB Data Cable Data Card Slot (accepts only Garmin Data Cards) Data Card Programmer iv Installation of the USB Programmer and Device Drivers 1. Insert either the USB Data Card Programmer CD-ROM, MapSource City Navigator CD-ROM, or MapSource Setup CD into your computer's CD-ROM drive. It is important you insert the CD before you plug the USB Programmer into the PC!If the MapSource program is open, close the program. Connect the USB connector on the end of the Programmer cable to the USB port on the back of the computer. The computer does not need to be turned off when connecting or disconnecting the Programmer. After connecting the Programmer to your computer you will need to install the device drivers from the CD-ROM. The computer will recognize the Programmer as a USB (or unknown) device and open the Add New Hardware Wizard and search for the device drivers. If, for some reason, the Wizard does not run automatically, click the Start button and select "Settings" and then "Control Panel". Double click on the "Add New Hardware" icon. The next screen will ask you if you want it to search for the best driver for your device or if you want to display a list to choose from. [. . . ] Then type in the drive letter of your CD-ROM drive followed by the MapSource Update file name: MSUPDATE. EXE. Press ENTER and follow on-screen instructions. Open MapSource and check the "About" box in the help file to determine that you have successfully installed Version 3. 04 or later. 4 To Install a Garmin Data Card: 1. Insert the Data Card (Label up and pin connector end first) into the card slot in the Programmer (standard USB Programmer pictured to the right). Installation Installing a Data Card in the Programmer For the Mini-USB Programmer, make sure the Garmin globe logo on the Programmer is facing UP for proper orientation. 2. [. . . ]