User manual GATEWAY GTW-MM103 Installation Guide

[. . . ] Assembly Instructions for GTW-WMM103 Flat Panel TV Wall Mount Thank you for choosing the Gateway GTW-MM103 manufactured by Sanus Systems. This product is designed to mount flat panel televisions weighing up to 175 lb. [. . . ] It is a good idea to verify where the studs are located with an awl or thin nail shown in Diagram 1-A. Predrill a 2. 5" deep hole at the desired height in each stud using a 3/16" drill bit. Make sure these holes are in the center area of the studs and level with each other . Use the Wall Plate as a template to mark the location of the second hole in each stud. Drill 2. 5" deep holes using the 3/16" drill bit in the marked locations. Attach the Wall Plate to the wall using four 1/4 x 2. 5" Lag Bolts (e) and four Lag Bolt Washers (d). Make sure the Wall Plate is oriented so the flat surface in the center of the plate is against the wall and that a set of Lag Bolts is on each side of the two large holes in the center as shown in Diagram 1-B. Diagram 1-A Diagram 1 - B 1b] Brick, Solid Concrete and Concrete Block mounting: Use the Wall Plate (a) as a template to mark 6 hole locations on the wall. The outer holes must fall to left and right of the two large holes in the middle of the plate. Three in the top row of slots and three more in the bottom row. Make sure these holes are level and there is at least 6" between any two holes. Pre-Drill these holes with a 1/2" masonry bit to at least 2. 5" in depth. Insert a Concrete Anchor (e) into each of these holes. [. . . ] Far Right: Bottom Rail and Safety Bolt. Sanus Systems 3785 Lexington Ave. Saint Paul Minnesota 55126 800. 359. 5520 www. sanus. com 052003 [. . . ]