User manual GE APPLIANCES 24" GAS RANGES

[. . . ] Under certain conditions, hydrogen gas may be produced in a water heater that has not been used for two weeks or more. Hydrogen gas can be explosive under these circumstances. If the hot water has not been used for two weeks or more, prevent the possibility of damage or injury by turning on all hot water faucets and allowing them to run for several minutes. Do this before using any electrical appliance which is connected to the hot water system. [. . . ] Drain all water from hoses if weather will be below freezing. Below are fabric care label "symbols" that affect the clothing you will be laundering. Dry Normal Permanent Press/ wrinkle resistant Gentle/ delicate Do not tumble dry Do not dry (used with do not wash) Line dry/ hang to dry If you have any questions, call 800. Read these instructions completely and carefully. WATER TEMPERATURE--Household water heater should be set to deliver water at 120° to 150°F (50° to 66°C) IN THE WASHER when HOT wash is selected. SHUT-OFF VALVES--Both hot and cold shut-off valves (faucets) should be supplied. DRAIN--Water may be drained into a standpipe or set tub. The discharge height MUST NOT BE LESS THAN 30" nor more than 8' above the base of the washer. The standpipe must be 11/2" minimum inside diameter and must be open to the atmosphere. Note to Installer ­ Be sure to leave these instructions with the Consumer. Note to Consumer ­ Keep these instructions for future reference. Improper connection of the equipment-grounding conductor can result in a risk of electrical shock. Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded. Do not modify plug with this appliance; if it will not fit the outlet installed, have a proper outlet installed by a qualified electrician. Do not kick or step on the leveling locks. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog up the water valve screens. NOTE: If the drain hose is placed in a stand pipe without forming a U shape, a siphoning action could occur. There must be an air gap around the drain hose. Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand, then tighten another 2/3 turn with pliers. Insure proper ground exists before use Before starting the washer, check to make sure: Main power is turned on. There are no leaks at the faucet, drain line or washer. NOTE: If your washer does not operate, please review the Before You Call For Service section. [. . . ] To know what your legal rights are, consult your local or state consumer affairs office or your state's Attorney General. Please have serial number and model number available when calling for service. During this limited one-year warranty, GE will also provide, free of charge, all labour and related service costs to replace the defective part. Service trips to your home to teach you how to use Replacement of house fuses or resetting of circuit Failure of the product if it is abused, misused, or used for other than the intended purpose or used commercially. [. . . ]