User manual GE APPLIANCES JGBP33

[. . . ] ge. com Ranges Self-Cleaning Gas Safety Instructions . . 2­7 Operating Instructions Aluminum Foil . . 8, 9 Installation Owner's Manual Instructions . . 32­43 & Installation Air Adjustment . [. . . ] You should clean the surface burners routinely, especially after bad spillovers, which could clog these holes. If heavy spillover occurs, remove the surface burners from the range. Lift up the cooktop and then lift out the surface burners. Troubleshooting Tips Clean these holes thoroughly on each burner. Drip Pans (if so equipped) Remove the grates and lift out the drip pans. Drip pans can be cleaned in a dishwasher or by hand. When replacing the drip pans, make sure they are in the correct position. Add 1/4 cup ammonia and let soak several hours or overnight. CAUTION: Do not clean the drip pans in a self-cleaning oven. Consumer Support 24 Safety Instructions ge. com Grate Sealed Burner Assemblies (on some models) Turn all controls OFF before removing the burner parts and drip pans (if so equipped). Electrode Burner cap The burner grates, caps, burner heads and drip pans (if so equipped) can be lifted off, making them easy to clean. Do not operate the cooktop without all burner parts, drip pans (if so equipped) and grates in place. Lifting the cooktop on sealed burner models can lead to damage and improper operation of the range. Burner head CAUTION: Drip pan (if so equipped) The electrode of the spark igniter is exposed when the burner head is removed. When one burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware. Operating Instructions Electrode Cooktop Installation Instructions Troubleshooting Tips Consumer Support 25 Safety Instructions Care and cleaning of the range. Burner Caps and Heads NOTE: Before removing the burner caps and heads, remember their size and location. Replace them in the same location after cleaning. Replacement Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size. On some models: Burner caps Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles. Medium head and cap Small head and cap Operating Instructions Burner heads For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it. Use a sewing needle or twist-tie to unclog the small hole in the burner head. Front of range Large head and cap Large head and cap The slits in the burner heads must be kept clean at all times for an even, unhampered flame. Clogged or dirty burner ports or electrodes will not allow the burner to operate properly. Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged. You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20­30 minutes. For more stubborn stains, use a toothbrush. Installation Instructions On some models: Medium head and cap Small head and cap Front of range Medium head and cap Large head and cap Troubleshooting Tips After cleaning Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes. [. . . ] s Incidental or consequential damage caused by possible defects with this appliance. s Product not accessible to provide required service. Installation Instructions EXCLUSION OF IMPLIED WARRANTIES--Your sole and exclusive remedy is product repair as provided in this Limited Warranty. Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law. WARRANTOR IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES. Warrantor: MABE CANADA INC. Troubleshooting Tips Consumer Support 55 Consumer Support. [. . . ]