User manual GE APPLIANCES WPXH214

[. . . ] As an ENERGY STAR® partner, GE has determined that this product meets the ENERGY STAR® guidelines for energy efficiency. Proof of the original purchase date is needed to obtain service under the warranty. fill out the Consumer Product Registration Card. Two easy ways to register your appliance! [. . . ] Carefully move the washer to within 4 feet (122 cm) of the final location. Remove the following from the back side of the washer: 4 bolts 4 yellow plastic spacers 3 metal "P" clamps Remove the large Styrofoam block located under the drum. Lift up on the drum, tilt the base of the foam block inwards toward the rear of the washer until free, and then pull the block out. Remove and discard the yellow ribbon and label from the front of the washer. From the rear of the washer, carefully pull out the power supply cord through the hole in the backsheet. Save all bolts, washers, spacers, brackets, clamps, and blocks for future use. NOTE: If you must transport the washer at a later date, you must reinstall the shipping support hardware to prevent shipping damage. Remove the service panel from the front of the washer. For a higher standpipe, contact an authorized parts distributor. If the drain is less than 24 (61 cm), install a siphon break kit, available at your local hardware store. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog up the water valve screens. Remove the inlet hoses and rubber washers from the plastic bag and install the rubber washers in each end of the inlet hoses. Tighten by hand, then tighten another 2/3 turn with pliers. Carefully connect the other inlet hose to the inside "C" outlet of the water valve. Tighten by hand; then tighten another 2/3 turn with pliers. Do not crossthread or over-tighten these connections. Connect the inlet hose ends to the HOT and COLD water faucets tightly by hand, then tighten another 2/3 turn with pliers. Carefully move the washer to its final location. With the washer in its final position, place a level on top of the washer (if the washer is installed under a counter, the washer should not be able to rock). Adjust the front leveling legs up or down to ensure the washer is resting solid. Turn the lock nuts on each leg up towards the base of the washer and snug with a wrench. nOTE: Keep the leg extension at a minimum to prevent excessive vibration. [. . . ] I Service trips to your home to teach you how to use I Replacement of house fuses or resetting of circuit I Failure of the product if it is abused, misused, or used for other than the intended purpose or used commercially. Com Have a question or need assistance with your appliance?Try the GE Appliances Website 24 hours a day, any day of the year!For greater convenience and faster service, you can now download Owner's Manuals, order parts, catalogs, or even schedule service on-line. [. . . ]