User manual GE APPLIANCES WSLP1500

[. . . ] Write the model and serial numbers here: You can find them on a label on the back of the washer. For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury or loss of life. The instructions in this manual and all other literature included with this washer are not meant to cover every possible condition and situation that may occur. Good, safe practices and caution MUST be applied when installing, operating and maintaining any appliance. [. . . ] Note to Installer ­ Be sure to leave these instructions with the Consumer. Note to Consumer ­ Keep these instructions for future reference. Skill level ­ Installation of this appliance requires basic mechanical skills. Completion time ­ 1 hour Proper installation is the responsibility of the installer. product failure due to improper installation is not covered under the Warranty. Note ­ This appliance must be properly grounded, and electrical service to the washer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70. Washer must be installed on firm flooring to minimize vibration during spin cycles. Concrete flooring is best, but wood base is sufficient providing floor support meets FHA standards. washer should not be installed on rugs or exposed to the weather. Install or store where it will not be exposed to temperatures below freezing or exposed to the weather. This appliance must be supplied with the voltage and frequency indicated on the rating plate (located on the back of the washer) and connected to an individual, properly grounded branch circuit, protected by a 15- or 20-amp circuit breaker or time-delay fuse. If the washer is plugged into the dryer's 115-volt outlet, then the dryer needs to be on a dedicated circuit. CAUTION: Before plugging in washer, read the following electrical requirements. eLECTRICAL REQUIREMENTS For personal safety, do not use an extension cord or adapter plug with this appliance. Do not, under any circumstances, cut or remove the third grounding prong from the power cord. follow National Electrical Codes or prevailing local codes and ordinances. This appliance must be supplied with the voltage and frequency indicated on the rating plate (located on the back of the washer) and connected to an individual, properly grounded branch circuit, protected by a 15- or 20-amp circuit breaker or time-delay fuse. If the electric supply provided does not meet the above requirements, call a licensed electrician. Before connecting the hoses, the washer must be level. Leveling locks are located at the bottom front of the left and right sides of the washer. Insure proper ground exists before use This appliance must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. [. . . ] Any implied warranties, including the implied warranties of merchantability or fitness for a particular purpose, are limited to one year or the shortest period allowed by law. This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within Canada. Do not dry Normal Normal Permanent Press/ Gentle/ Sans repassage/ Doux/délicat Do not tumble dry Ne(used sécher Ne pas sécher pas with do not avec wrinkle resistant delicate infroissables par culbutage (utiliséwash) ne pas laver) No secar en Do not tumble dry secadora Do not dry (used with No secar do not wash) Line dry/ Colgar para secar hang to dry Com Have a question or need assistance with your appliance?Try the GE Appliances Website 24 hours a day, any day of the year! [. . . ]