User manual GE 290000

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. Save these original instructions for future reference. [. . . ] However, to obtain "no charge" emissions control service, the work must be performed by a factory authorized dealer. Disconnect the spark plug wire and keep it away from the spark plug. Do not tamper with governor spring, links or other parts to increase engine speed. Other parts may not perform as well, may damage the unit, and may result in injury. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. Do not check for spark with spark plug removed. First 5 Hours Change oil Every 8 Hours or Daily Check engine oil level Clean area around muffler and controls Every 100 Hours or Annually Clean or change air filter * Change engine oil and filter Replace spark plug Check muffler and spark arrester Every 250 Hours or Annually Check valve clearance. Every 400 Hours or Annually Clean air cooling system * Clean oil cooler fins * In dusty conditions or when airborne debris is present, clean more often. Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. With the throttle control (B) in the slow position, turn the key switch (D) to the off position (Figure 3). Remove the key and keep in a safe place out of the reach of children. Push the stop switch (F) to the off position. After the engine stops, turn the fuel shut-off valve (A), if equipped, to the closed position. Engine parts, especially muffler, become extremely hot. Allow muffler, engine cylinder and fins to cool before touching. Remove accumulated debris from muffler area and cylinder area. It is a violation of California Public Resource Code, Section 4442, to use or operate the engine on any forest-covered, brush-covered, or grass-covered land unless the exhaust system is equipped with a spark arrester, as defined in Section 4442, maintained in effective working order. Other states or federal jurisdictions may have similar laws. Fuel and its vapors are extremely flammable and explosive. Never start or run the engine with the air cleaner assembly (if equipped) or the air filter (if equipped) removed. Remove accumulated debris from muffler area and cylinder area. [. . . ] the warranty on emissions-related parts is as follows: 1. Warranted Emissions Parts Coverage under this warranty extends only to the parts listed below (the emissions · Any warranted part that is not scheduled for replacement as required control systems parts) to the extent these parts were present on the engine maintenance in the owner's manual supplied, is warranted for the warranty purchased. If any such part fails during the period of warranty coverage, the part will be repaired or replaced by B&S at no charge to the a. Any warranted part that is scheduled only for regular inspection in the owner's · Fuel line, fuel line fittings, clamps part repaired or replaced under warranty will be warranted for the remaining · Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled c. [. . . ]