User manual GE 29869B

[. . . ] Your telephone equipment is approved for connection to the Public Switched Telephone Network and is in compliance with parts 15 and 68, FCC Rules and Regulations and the Technical Requirements for Telephone Terminal Equipment published by ACTA. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the US number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company. The REN is useful in determining the number of devices you may connect to your telephone line and still have all of these devices ring when your telephone number is called. [. . . ] The unit announces the rings to answer, then enters the incoming message length menu. This feature allows you to know if you have new messages when calling the machine from a remote phone. If you have new messages, the unit will ring twice before answering. if you don't , it will ring four times. This allows you to hang up before the machine answers so that you don't have to pay toll charges. Press and release NEXT or PREVIOUS until the unit announces and displays the correct incoming message length. The unit announces the message length, then enters the security code menu. The security code is a programmable 4-digit code which can be used to access remote functions. IMPORTANT: The first digit is factory set at zero and cannot be changed. The unit announces the current security code. Press and release NEXT or PREVIOUS to choose the second digit (the first digit is not programmable). The unit announces all 4 digits, but only the selected digit will change. Once you have the desired second digit, press SET to save it and move on to the third digit. Press and release NEXT or PREVIOUS to choose the third digit. Once you have the desired third digit, press SET to save it and move on to the fourth digit. Press and release NEXT or PREVIOUS to choose the fourth digit. Once you have the desired fourth digit, press SET to save it. NOTE: To exit any menu, press and release STOP. also , setup will cancel if no buttons have been pushed within 30 seconds. IMPORTANT: The setup settings will not be erased even after a power outage. The unit beeps when it is not announcing a setting or playing a message. The GREETING indicators let you know what greeting will be used to answer a call. [. . . ] Was the AC power supply unplugged from back of unit?Auto disconnect is delayed for 2 seconds after the unit answers a call. If you are near the unit, press STOP to stop the greeting. Can't hear messages Unit announces "Battery Low" Can't restart message Messages indicator flashes rapidly Battery good but messages were lost Greeting continues to play even after an extension phone is picked up 6 (or hang up during menu playback) To set rings to answer and message limit . [. . . ]