User manual GE 310000 REVISION B

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. Save these original instructions for future reference. [. . . ] Check engine oil level Clean area around muffler and controls Clean finger guard (if equipped) Change engine oil Replace oil filter (if equipped) Check muffler and spark arrester Replace air filter Replace pre-cleaner Replace spark plug Clean air cooling system * Check valve clearance ** In dusty conditions or when airborne debris is present, clean more often. ** Not required unless engine performance problems are noted. NOTICE: The manufacturer of the equipment on which this engine is installed specifies the top speed at which the engine will be operated. Disconnect the spark plug wire and keep it away from the spark plug. Do not tamper with governor spring, links or other parts to increase engine speed. Other parts may not perform as well, may damage the unit, and may result in injury. ⷠDo not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. Remove accumulated debris from muffler area and cylinder area. If damage is found, install replacement parts before operating. Other parts may not perform as well, may damage the unit, and may result in injury. Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 6). Note: Any of the oil drain plugs shown below may be installed in the engine. After the oil has drained, install and tighten the oil drain plug. Disconnect the oil drain hose (G, Figure 8) from the side of the engine. Carefully lower the quick oil drain (I) into an approved container (J). After the oil has drained, install the oil drain cap. Some models are equipped with oil filter. Before you install the new oil filter, lightly lubricate the oil filter gasket with fresh, clean oil. Install the oil filter by hand until the gasket contacts the oil filter adapter, then tighten the oil filter 1/2 to 3/4 turns. As the engine warms up, check for oil leaks. [. . . ] the warranty on emissions-related parts is as follows: 1. Warranted Emissions Parts Coverage under this warranty extends only to the parts listed below (the emissions · Any warranted part that is not scheduled for replacement as required control systems parts) to the extent these parts were present on the engine maintenance in the owner's manual supplied, is warranted for the warranty purchased. If any such part fails during the period of warranty coverage, the part will be repaired or replaced by B&S at no charge to the a. Any warranted part that is scheduled only for regular inspection in the owner's · Fuel line, fuel line fittings, clamps part repaired or replaced under warranty will be warranted for the remaining · Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled c. [. . . ]