User manual GE 540000

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with engines and how to avoid them. It also contains instructions for the proper use and care of the engine. Because Briggs & Stratton Corporation does not necessarily know what equipment this engine will power, it is important that you read and understand these instructions and the instructions for the equipment. Save these original instructions for future reference. [. . . ] However, to obtain "no charge" emissions control service, the work must be performed by a factory authorized dealer. Before performing adjustments or repairs: Disconnect the spark plug wire and keep it away from the spark plug. Do not tamper with governor spring, links or other parts to increase engine speed. replacement parts must be of the same design and installed in the same position as the original parts. Other parts may not perform as well, may damage the unit, and may result in injury. Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. when testing for spark: Use approved spark plug tester. Do not check for spark with spark plug removed. Change oil Check engine oil level Clean area around muffler and controls Clean or change air filter * Y Change engine oil and filter Replace spark plug Check muffler and spark arrester Check valve clearance. Change air filter Y Clean air cooling system * Clean oil cooler fins * Change safety filter (if equipped) In dusty conditions or when airborne debris is present, clean more often. Every third air filter change, replace the inner safety filter (if equipped). Remove accumulated debris from muffler area and cylinder area. If damage is found, install replacement parts before operating. Other parts may not perform as well, may damage the unit, and may result in injury. Used oil is a hazardous waste product and must be disposed of properly. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 6). After the oil has drained, install and tighten the oil drain plug. Note: To remove the panel on engines equipped with the Cyclonic Air Filter System (G, Figure 10), loosen the fastener (H) and pivot the Cyclonic Air Filter away from the engine. it is not necessary to remove the flexible air cleaner hose (J). After cleaning, make sure to reposition the air filter and tighten the fastener. If the air filter is excessively dirty, replace with a new air filter. [. . . ] ignition System replacement point for the part. Spark plug(s) Magneto ignition system Add on or modified parts that are not exempted by the Air Resources Board may not be used. The use of any non exempted add on or modified parts by the d. catalyst System owner will be grounds for disallowing a warranty claim. [. . . ]