User manual GE SIDE-BY-SIDE REFRIGERATOR 27

[. . . ] Write the model and serial numbers here: Model # __________________________ Serial # __________________________ Find these numbers on a label inside the refrigerator compartment at the top on the right side. Use this appliance only for its intended purpose as described in this Owner's Manual. When using electrical appliances, basic safety precautions should be followed, including the following: I This refrigerator must be properly installed and located in accordance with the Installation Instructions before it is used. I Do not allow children to climb, stand or hang on the shelves in the refrigerator. [. . . ] Note to Consumer ­ Keep these instructions for future reference. Skill level ­ Installation of this appliance requires basic mechanical skills. Proper installation is the responsibility of the installer. If the refrigerator has already been installed, remove the base grille (see Step 2 in Moving the Refrigerator), then skip to Step 5 in Installing the Refrigerator. Leave all tape and door pads on doors until the refrigerator is in its final location. To move the refrigerator, use a padded hand truck. Center the refrigerator on the hand truck and secure the strap around the refrigerator. If the refrigerator must go through any entrance that is less than 38 wide, the doors must be removed. If all entrances are more than 38 wide, skip to Installing the Refrigerator. If the refrigerator has a water dispenser, there is a water line from the cabinet into the bottom hinge on the freezer door that must be disconnected. To disconnect, push in on the white collar of the coupling and pull out the tubing. Remove the grille by removing the two Phillips head screws. If the refrigerator has a water dispenser, there is a power line (harness) from the cabinet into the bottom hinge on the freezer door that must be disconnected. A Remove the freezer door top hinge cover by either squeezing it and pulling it up or by prying it off with a plastic putty knife. If the refrigerator has a refreshment center, there are electrical connectors (harnesses) from the cabinet into the bottom hinge on the refrigerator door that must be disconnected. To disconnect, pull apart each connector. B Remove the two 5/16 hex head screws, then lift the hinge straight up to free the hinge pin. D As one person slowly lifts the freezer door up and off the bottom hinge, the second person should carefully guide the water line and power line (harness) through the bottom hinge. B Remove the two 5/16 hex head screws, then lift the hinge straight up to free the hinge pin. Set the door on a non-scratching surface with the inside up. A Remove the refrigerator door top hinge cover by either squeezing it and pulling it up or by prying it off with a plastic putty knife. To replace the doors, simply reverse steps 3 through 8. [. . . ] To know what your legal rights are, consult your local or state consumer affairs office or your state's Attorney General. Pour dégager le support du bac à produits laitiers, tirez sur les tiges latérales du support pour les retirer des trous situés sur les côtés du bac. Com Have a question or need assistance with your appliance?Try the GE Appliances Website 24 hours a day, any day of the year! [. . . ]