User manual GEHA OFFICE X12 CD

[. . . ] Always comply with the following basic precautions. This file shredder has been designed specifically for the shredding of paper and CDs. Do not attempt to feed foils, adhesive labels, clothing, or plastic materials into the file shredder. Remove all paper clips before shredding paper. [. . . ] `rEv` By pressing the button `REV`, you can initiate the reverse operation of the cutting mechanism in case of a paper jam. When the sensor detects that the waste paper container is full, the device stops automatically and the red LED `Bin Full` lights up, and the LCD display will show `Basket Full`. First remove all paper from the feeder, and then empty the waste paper container. please note the instructions in the section: `Maintenance` b. Feeding cDs/DvDs, credit cards and floppy Disks into the shredder This device is equipped with a separate cutting mechanism for CDs/DVDs, credit cards and floppy disks. If you would like to utilise this function, proceed as follows: 1. switch on the file shredder by pressing the power button on the rear of the device. The green LED `Power` lights up, and the operating mode (Ready) and current time are shown in the LED display. (See section C for setting the current time) 2. Any CDs/DVDs, credit cards and floppy disks in the CD slot are detected automatically, the device starts up and the operating mode `In Use` is shown on the LCD display. CDs/DVDs, credit cards and floppy disks are shredded into 10 mm wide strips. Make sure to keep your face well away from the feeder slot when shredding CDs/DVDs, since these types of material always pose a hazard of splintering!By pressing the button `FWD`, you can now increase the hour displayed, and by pressing the button `REV` you can decrease the hour displayed. By pressing the button `FWD`, you can now increase the minutes displayed, and by pressing the button `REV` you can decrease the minutes displayed. Important note: The device will switch off automatically if the motor temperature increases too much. The red LED `overheat` lights up and signals that the overheat protection of the device has been activated the LcD display shows `Please Wait`. If that is the case, the device will not react when you press the button `rEv` or `fWD`. The device switches back into normaloperation as soon as the motor has cooled sufficiently. The number of sheets fed in is too high. Please wait until the display shows `Ready`. Continue operation when the display shows `Ready`. MaINTENaNcE Important: Pull the mains power plug from the wall socket before carrying out any maintenance tasks on the file shredder! [. . . ] If the device is still not working after you have tried the above solutions, please remove the mains power plug from the wall socket and consult your retailer. DIsPosaL The symbol depicting a crossed-out rubbish bin means that electrical devices may not be disposed of with regular household waste. please bring the device to an approved recycling centre for environmentally firendly disposal. GaraNTIE The warranty period for your device is 24 months. [. . . ]