User manual GEMINI MPX-30

[. . . ] CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] DIRECT SELECT: Use the DIRECT SELECT (14) section to access a track directly without scrolling through to find it or to create a programmed set list (see PROGRAM). With CD(s) you may key in the specific track you would like to play, in order to instantly scan through the track list to the selected track. With MP3 you may key in the specific track you would like to play, by keying in the track number & then press SET in order to instantly scan through the track list to the selected track. DSP EFFECTS: The MPX-30 comes equipped with 8 Digital Signal Processor (DSP) Effects. FILTER, ZOOM, ECHO, PAN, REVERSE, TRANSFORM, BRAKE and SCRATCH, are all DSP effects that can be futher modified by the DRY/WET (28), START (30), and BRAKE (31) rotary control knobs. see respective functions for more information: 23. ECHO: ECHO (34) is when the original signal is delayed when being input and then fed back into the signal creating the Echo effect. PAN: PAN (35) simply pans the sound from the left and to the right. It will speed up or slow down as you increase or decrease the parameter setting. TRANSFORM: TRANSFORM (37) simply cuts the sound from the left and right stereo levels. It will speed up or slow down as you increase or decrease the parameter setting. ZOOM: Mixing the signal with a slightly delayed copy of itself, where the length of the delay is constantly changed, creates ZOOMING. This resembles the sound of a plane taking off and landing. BRAKE: The BRAKE (38) button simulates the sound of a record stopping/starting on a turntable. The higher or lower the parameter the longer or shorter it takes for the record to stop. FILTER: The FILTER (32) goes through three passes during parameter adjustment: - Low Pass filters out the other frequencies except the low frequency. With a lower parameter you will hear it more. - High Pass filters out the other frequencies except the high frequency. With a higher parameter you will hear it more. - Band Pass filters out the other frequencies except the mid-range frequency. With the parameter setting in the middle you will hear it more. REVERSE: The REVERSE (36) button simply plays the track in REVERSE. [. . . ] When you are satisfied with your point of cue, leave the CUE (7) button alone, the CUE (7) LED will remain on to indicate that the point of cue is stored and ready to be used. Press HOT START (17) for instant play at your point of cue. If the disc turns but there is no sound, check the cable connections. If they are okay, check your amplifier or receiver. [. . . ]