User manual GEMINI PDM-01

[. . . ] CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interference with electric appliances such as radios and televisions, use shielded cables and connectors for connections. the exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. The lightening flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Use the LN SWITCH (40) to toggle from PH 1/LN 2 (16) to LN 3 (17) on this channel. Slowly raise the CH 2 SLIDE CONTROL (42) to a comfortable level, once you've selected the proper line. CH 3: To bring this channel into PGM, you must first decide which LN will be in use. Use the LN SWITCH (43) to toggle from PN 2/LN 4 (12) to LN 5 (13) on this channel. Slowly raise the CH 3 SLIDE CONTROL (45) to a comfortable level, once you've selected the proper line. CH 4: To bring this channel into PGM, you must first decide which LN will be in use. Use the LN SWITCH (46) to toggle from LN 6 (10) to LN 7 (9) on this channel. Slowly raise the CH 4 SLIDE CONTROL (48) to a comfortable level, once you've selected the proper line. CUE: By connecting a set of headphones to the HEADPHONE (26) jack, you can monitor any or all channels. Use the rotary CUE VOLUME CONTROL (25) to adjust the CUE volume without changing the overall mix. By moving the CUE/PGM FADER CONTROL (24) to the LEFT you will be able to monitor the assigned CUE signal. Moving the CUE/PGM FADER CONTROL (24) to the MIDDLE allows CUE mix with PGM. Moving the CUE/PGM FADER CONTROL (24) to the RIGHT allows you to monitor PGM output. ASSIGN: There are 2 rotary controlled X FADER ASSIGN SWITCHES (34, 35), each having 5 settings OFF, 1, 2, 3, & 4. All operating instructions should be read before using this equipment. To reduce the risk of electrical shock, do not open the unit. Do not expose this unit to direct sunlight or to a heat source such as a radiator or stove. This unit should be cleaned only with a damp cloth. When moving this equipment, it should be placed in its original carton and packaging. This will reduce the risk of damage during transit. Before plugging the power cord in, make sure that the VOLTAGE SELECTOR (1) switch is set to the correct voltage. Before plugging the power cord in, make sure the POWER SWITCH (21) located on the face panel is turned OFF. [. . . ] Be sure your CH slide controls are at zero so the sample does not play in PGM. Follow the SAMPLE RECORDING instructions to complete the process. The blue CUE SAMPLER LED will illuminate while in use. Use the CUE controls to monitor this sample. [. . . ]