User manual GEMINI TT-01

[. . . ] Never spill liquid of any kind on the product. SERVICING: Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. refer all servicing to qualified service personnel. DAMAGE REQUIRING SERVICE: Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: · If the product does not operate normally by following the operating instructions. [. . . ] If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. SAFETY CHECK: Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING: The product should not be mounted to a wall or ceil ing. HEAT: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. POWER-CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. OUTDOOR ANTENNA GROUNDING: If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, loca Prior to use, we suggest that you carefully read all the instructions. Replace the platter and rotate the PLATTER (2) until the MOTOR SPINDLE (5) is visible, then fit your fingers in hole on the top of the PLATTER (2), feel for and grab the rubber belt and attach to the motor spindle. +/-10% Variable pitch slider Solid aluminum platter Straight tonearm for superior tracking Fully adjustable counter weight & anti-skating controls Dual speed RPM (33/45) LED Illuminated soft touch start/stop & RPM buttons Removable head shell CN-1000 cartridge & felt slipmat included RCA & ground cables Set the TURNTABLE BASE (1) on a flat, level surface free of vibration. Use the turntable feet to stabilize the unit horizontally. Try to place the unit as far away from the speakers as possible. Keep the unit away from direct exposure to the sun, heat, moisture or dirt. Read all operating instructions before using this equipment. The apparatus should not be exposed to dripping or splashing, and no objects filled with liquids such as vases should be placed on the apparatus. To reduce the risk of electrical shock, do not open the unit. tHERE ARE NO USER REPLACEABLE PARTS INSIDE. Please contact the Gemini Service Department or your authorized dealer to speak to a qualified service technician. Be sure that all AC power is OFF while making connections. Cables should be low capacitance, shielded and of proper length. [. . . ] Lower the TONE ARM (9) slowly, while letting go of the TONE ARM (9) over the record where you want to play. When play is over, raise the TONE ARM (9), move it onto the ARM REST (13), and secure it with the ARM CLAMP (12). You now have the option of turning off the power by turning the POWER (15) switch to the "OFF" position, or stopping the PLATTER (2) by pushing the START/STOP (17) button. Pushing the START/STOP (17) button will cause the record to stop exactly when the START/STOP (17) button is pressed while playing. [. . . ]