User manual GEMINI TT-02

[. . . ] OBJECT AND LIQUID ENTRY: Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product. SERVICING: Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. refer all servicing to qualified service personnel. [. . . ] If this product is equipped with a three-wire grounding type plug, a plug having a third (grounding) pin, it will only fit into a grounding type power outlet. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding type plug. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards. SAFETY CHECK: Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING: The product should not be mounted to a wall or ceil ing. HEAT: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. POWER-CORD PROTECTION: Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product. OUTDOOR ANTENNA GROUNDING: If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Prior to use, we suggest that you carefully read all the instructions. Rotate the PLATTER (2) until the VOLTAGE SELECTION SWITCH (3) (located on the TURNTABLE BASE (1)) is visible through one of the platter holes. Make sure that the VOLTAGE SELECTOR switch is set to the correct voltage. +/-10% Variable pitch slider Solid aluminum platter Straight tonearm for superior tracking Fully adjustable counter weight & anti-skating con trols Dual speed RPM (33/45) LED Illuminated soft touch start/stop & RPM but tons Removable head shell CN-1000 cartridge & felt slipmat included RCA & ground cables Set the TURNTABLE BASE (1) on a flat, level surface free of vibration. Use the turntable feet to stabilize the unit horizontally. Try to place the unit as far away from the speakers as possible. Keep the unit away from direct exposure to the sun, heat, moisture or dirt. 1) Because all cartridges have their own designs, please refer to your particular cartridge's instructions to insure proper installation. If you are using a pre-mounted or integrated cartridge, you can jump ahead to HEADSHELL INSTALLATION: 1. connect the lead wires to the cartridge terminals. For your convenience, the terminals of most cartridges are color-coded. connect each lead wire to the terminal of the same color. [. . . ] You now have the option of turning off the power by turning the POWER (13) switch to the "OFF" position, or stopping the PLATTER (2) by pushing the START/STOP (15) button. Pushing the START/STOP (15) button will cause the record to stop exactly when the START/STOP (15) button is pressed while playing. Press the START/STOP (15) button again to start playback with a short DELAY effect. When the PITCH CONTROL is in the center position, the speed will be 33 or 45 depending on which SPEED SELECTOR (16) button is pushed. [. . . ]