User manual GENERAL ELECTRIC AGM05

[. . . ] Because we do not necessarily know all the applications this equipment could be used for, it is important that you read and understand these instructions thoroughly before attempting to start or operate this equipment. Save these instructions for future reference. This home standby generator requires professional installation before use. refer to the separate installation manual for full information. [. . . ] this completes the test procedures for automatic operation. The home generator will now start automatically and will supply power to the transfer switch when utility power is lost. The home generator is equipped with an exercise timer that will start and exercise the system once every seven days. During this exercise period, the unit runs for approximately 20 minutes and then shuts down. Electrical load transfer DOES NOT occur during the exercise cycle (unless an utility power outage occurs). The specific day and the specific time of day this button is pressed is programmed into the control board memory. This date and time is then used to automatically initiate the system exercise cycle. For example, if you press SET EXERCISE on Sunday morning at 10:00 AM, the unit will run an immediate exercise cycle and an exercise cycle every following Sunday at 10:00 AM (+/- 1/2 hour). "Set Exercise" will only work if the unit is in the AUTO mode and this exact procedure is followed. The exerciser will need to be re-set if the 15 Amp fuse is removed or changed, or if the starting battery is disconnected. If you want to change the day and time the unit exercises, simply perform the "Set Exercise" procedure at the exact weekday and time you want it to take place. reinstall the battery (replace if necessary - see Battery in Final Installation Considerations in the installation manual). Then reset the fault detection system, as described earlier. This fault is indicated by fault code FC_2. The unit is equipped with an oil pressure switch that uses normally closed contacts held open by engine oil pressure during operation. Should oil pressure drop below the 8 psi range, switch contacts close and the engine is shut down. To remedy the low oil pressure condition, add the recommended oil to the FULL mark on the dipstick. If the low oil pressure condition still exists, the engine will start, then shut down again. This fault is indicated by fault code FC_5. This feature protects devices connected to the transfer switch by shutting the generator down if the engine runs slower than 55 Hz for three seconds. This condition is caused by a failed engine component or by excessive loads on the generator. This fault is indicated by fault code FC_6. [. . . ] "Rental use" means any use of this product in a temporary or semi-permanently installed rental application. Once equipment has experienced rental use, it shall thereafter be considered rental use for purposes of this warranty. 4 years or 1, 600 hours, whichever comes first None None None For purposes of this warranty, "Prime Power" is defined where the generator is a source of power where no electrical power is available from the UTILITY POWER GRID. If no UTILITY power is available, the generator is considered the prime power source. [. . . ]