User manual GENERAL ELECTRIC AGN05

[. . . ] This generator system is designed and intended only for use as an optional home standby system that provides an alternate source of electric power and to serve loads such as heating, refrigeration systems, and communication systems that, when stopped during any power outage, could cause discomfort or inconvenience. Save these original instructions for future reference. This generator requires professional installation before use. You never have to look far to find support and service for your generator. [. . . ] 5 m) minimum clearance from any structure, shrubs, trees or any kind of vegetation. Standby weatherproof enclosure must have a minimum of 4 feet (1. NOTICE DO NOT place weatherproof enclosure under a deck or other type of covered structure that may confine airflow. Install the standby generator in a location where sump pump discharge, rain gutter down spouts, roof run-off, landscape irrigation, or water sprinklers will not flood the unit or spray the enclosure and enter any air inlet or outlet openings. Install the standby generator where it will not affect or obstruct any services (including covered, concealed and underground), such as telephone, electric, fuel (natural gas / LPG vapor), irrigation, air conditioning, cable, septic, sewer, well and so forth. Install the standby generator where leaves, grass, snow, etc will not obstruct air inlet and outlet openings. If prevailing winds will cause blowing or drifting, you may need to construct a windbreak to protect the unit. Engines, and their weatherproof housings if provided, that are installed outdoors shall be located at least 1. 5m (5 ft) from openings in walls and at least 1. 5 m (5 ft) from structures having combustible walls. A minimum separation shall not be required where either of the following conditions exist: 1. Close control panel door and insert key into lock and turn key one quarter turn clockwise. The home generator is equipped with a removable roof and removable side panels to permit simple servicing. Move roof latch to the left until roof pops up slightly. WARNING Contact with muffler area could cause burns resulting in serious injury. DO NOT touch hot parts and AVOID hot exhaust gases. Allow equipment to cool before touching. Remove two screws B and pull muffler cover off. Push latches down on both sides of panel to lock into place. The information below is provided to assist gaseous fuel system technicians in planning installations. In no way should this information be interpreted to conflict with applicable fuel gas codes. Consult with your local fuel supplier or Fire Marshall if questions or problems arise. [. . . ] utility Voltage Pickup Sensor This sensor monitors utility power supply voltage. When that voltage is restored above 80 percent of the nominal source voltage, a time delay starts timing and the engine will go to engine cool-down. engine Cool-down Timer · When the load is transferred back to the utility power source, the engine cool-down timer starts timing. The timer will run for about one minute, then the generator will stop. [. . . ]