User manual GENERAL ELECTRIC AGR05

[. . . ] This manual contains safety information to make you aware of the hazards and risks associated with this system and how to avoid them. We have made every effort to provide for a safe, streamlined and cost-effective installation. As each installation is unique, it is impossible to know of and advise of all conceivable procedures and methods by which installation might be achieved. We do not know all possible hazards and/or the results of each possible method or procedure. [. . . ] Example of two 240VAC air conditioner loads controlled by thermostat. Example of two 120VAC loads controlled by 50 Amp remote module. Example of one 240VAC load controlled by 50 Amp remote module. NOTICE Improper installation could cause damage to the circuit boards and shorten their life. Installing circuit boards in live circuits will damage the board and is not covered by warranty. Remove all power prior to installing this equipment. Failure to do so could cause internal damage to the board when making electrical connections. Turn off utility power to the standby generator and transfer switch. All wiring must be the proper gauge, properly supported and protected by conduit. All wiring should be done per applicable federal, state and local codes, standards and regulations. Installing low and high voltage wire in same conduit could result in death, serious injury and/or property damage. To return to utility power, turn the utility service disconnect circuit breaker to the "ON" position. Utility Fail The generator senses when utility voltage is below 70 percent of nominal. Engine start sequence is initiated after 6 second time delay. Engine Warm-Up Time delay to allow for engine warm-up before transfer. Use jumper on transfer switch control board to select delay of 20 seconds or 50 seconds. Transfer Transfer from utility to generator supply occurs after voltage is above set levels. The transfer switch control board LED lights will change from green (utility) to red (generator) and the Symphony II status light will change blink status from Blink Blink_Pause_Blink Blink to Blink_Pause_Blink. Minimum engine run time is 5 minutes after transfer. Despite the safe design of the system, operating this equipment imprudently, neglecting its maintenance or being careless can cause possible injury or death. The Symphony II system can be tested under either utility power or generator power. Only one priority LED and associated remote module will be powered (ON) at a time during test mode. [. . . ] Install noise filter in series and close to problematic device. Rewire remote module to opposite power line (L1 or L2) from that of problematic device. Briggs & Stratton Power Products Group, LLC will repair or replace, free of charge, any part(s) of the equipment that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. [. . . ]