User manual GENIUS DV813

[. . . ] English FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1). This device may not cause harmful interference, and (2). This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. [. . . ] or con displayed on the screen The table below will help you choose the appropriate self-timer mode: Self-timer mode Description The image is captured about three seconds after the 3 seconds-delay shutter button is pressed. The image is captured about ten seconds after the shutter button is pressed. The Self-timer LED starts 10 seconds-delay blinking relatively slow for 7 seconds and then blinking rapidly for the last 3 seconds. -36- English NOTE The self-timer does not function in Movie Mode. The self-timer setting is automatically cancelled after an image is captured. Continuous Capture This function allows you to capture a sequential burst of three images with one press of the shutter button. The continuous capture mode is very useful for photographing objects in motion where it is difficult to determine the precise moment of capture. Afterwards, you may review the sequence of shots to select the best one. Make sure the digital video camera is in Capture Mode. button. When this function is enabled, the 3. Compose the image, and then press the NOTE Continuous capture cannot not be activated while the image resolution is set to 8MP or 6MP. In continuous capture mode, the flash cannot be used. -37- English PLAYBACK MODES Video Playback You can play back video clips recorded on the digital video camera. Slide the Mode switch to the Press the side. button continuously until the Movie/Still-image Playback Mode appears. The last video clip/image appears on the screen. Select the desired video clip or image with the / 5. button to play the selected Press the video clip. To pause playback at any time, press the button again. To stop playback, press the button. NOTE To adjust the volume of those videos that include audio, press the increase the volume, press the button to decrease the volume. button to -38- English Still-Image Playback You can view your still-images, enlarge them for detailed viewing, or run a slide show. Make sure the digital video camera is in Movie/Still-Image Playback Mode. The last video clip/image appears on the screen. Select the desired video clip/image with the Pressing the / / buttons. buttons during still-image playback will result in a 90 degree button rotates the image clockwise and displays it, rotated display. The whereas the button rotates the image counterclockwise and displays it. A press of the button opposite to the direction in which the image was rotated will return the image to the normal display. Playing Back Videos and Still Images on a TV Monitor You can also play back your videos and images on a TV screen. Before connecting to any video device, however, make sure to select, on the digital video camera, the video broadcast standard (NTSC or PAL) which matches the video broadcast standard of the video equipment you are going to connect to the digital video camera. [. . . ] Although it is set to Auto Focus, it does not focus. The flash does not fire. The flash cannot recharge. -69- English Symptom Even though the flash fired, the image is dark. The image is too dark. Cause The distance to the subject is greater than flash effective range. The image was captured in a dark place while set to flash off. [. . . ]