User manual GENIUS G-NOTE 7000

[. . . ] Welcome Dear user, thanks for purchasing this product. Much investment in time and effort has gone into its development, and it is our hope that it will give you many years of trouble-free service. Notice 1. Purchasing new ink cartridges: The dimension of the pen cartridge is 2. 3~2. 4mm (diameter) x 67mm (length). You are recommended to use products of tested brands, such as KANGHER, MINI STAR, SCHMIDT 628F, and ROTRING. [. . . ] Under such circumstances, you should erase some unwanted contents if you need to continue writing on the same pages. You can also use a new memory card, but the old pages will become inaccessible and you need to start writing on a whole new page. The size of one stored page depends on the strokes and words you write on the page. The more you write, the larger the file size will be. When the memory is full and no more space is available, the pen icon (p. 7) will not appear if you continue writing. 8 Operation with the function buttons There are five function buttons on the left side of the digital pad. You can use them to perform many useful actions to assist your page management. English Create a new blank page To create a new blank page, press the button. Function buttons Shift between pages To move to the previous page, press the button. To move to the next page, press the button. Note that you cannot move to a page that is not yet created. When you switch the paper page, be sure to switch the digital page accordingly, so that the contents of both pages can stay aligned. Erase page contents To erase the digital contents of current page, press the button. Then a prompt message will appear on the LCD screen. Use the or button to select "Yes" and press the button to confirm. After the contents are erased, the page icon will become . You should then remove or cross out the same paper page and start a new page accordingly. The erased contents are gone forever and cannot be recovered. Erase paper contents with an eraser does not erase the digital contents accordingly. When the prompt message appears, you can still record your writing as the pen icon displays. If you do not want to erase anything, simply select "No" and press the button upon seeing the prompt message. 9 Create a new folder To create a new folder, press the button. You will see an English letter blinking on the LCD panel. Press the button and the letter will change. Then press the button again and a new folder is created. English Shift between folders Press the button and you will see an English letter blinking on the LCD panel. Use the or button to select your desired folder and then press the button again to confirm. Turn off the digital pad To turn off the digital pad, slide the power switch upward as indicated. Next time when you switch on the digital pad again, you will be automatically led to the last edited page. 10 Replace the cartridge of the pen The cartridge compartment can contain up to two replacement cartridges. When the ink cartridge is running out of ink or you want to use a dummy cartridge, you can replace the old cartridge with a new one. English 1 Open the cartridge compartment cover. Slide open the cartridge compartment cover on the lower right side of the digital pad. Inside the compartment you can find two replacement cartridges. 2 Pull out the old cartridge. 3 or Insert the pen tip into the clip hole in the cartridge compartment. [. . . ] Try using more force or slowing down your speed when writing. Try to keep the tilting angle of the pen and the pad more than 60 degrees. English When writing on the digital pad, the pen icon does not display on the LCD screen. The pen icon keeps displaying on the LCD screen even though I am not writing at all. The pen strokes in the digital page become longer, shorter, or even missed in some parts. The pen strokes in the digital page are seriously distorted, dragging, or missed. a. If the digital pen has been used for a period of time, check if the battery power has been depleted. If the pen cartridge has been replaced, check if the cartridge was correctly installed. [. . . ]