User manual GENIUS HR7XSLIM

[. . . ] User's Guide Genius Scanner All trademarks and brand names mentioned in this publication are property of their respective owners. No portion of this document may be reproduced without permission. Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 How to Use This Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Conventions of this Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Ensure that the ready-to-be-scanned film compartment must be positioned on the center of the scanner glass, and the arrow sign of the particular film compartment must be in alignment with the inverse-arrow sign carved on the scanner housing. b. c. d. Note: If you are scanning 35mm slides, place the film holder on the scanner first, Attention then place the slides in the holder. 4. Select POSITIVE FILM or NEGATIVE FILM as the scan source by clicking the SCAN SOURCE button on the Genius TWAIN window. Select 35mm, 120/220 (6x6 cm) film, or 120/220 (6x9 cm) film as the scan size. Click on the PREVIEW IMAGE icon to preview the image. Adjust the scanning border, if necessary. Click on the SCAN IMAGE icon to start scanning the image. Important Notes about Scanning Film !Do not cover any small compartment below each arrow sign on the film holder because that it is necessary for calibration. !Always replace the reflective document mat onto the scanner's document cover after you finish scanning the films. Genius Scanner 14 !Make sure the film is properly loaded into the film holder and the film holder is correctly positioned on the scanner glass. !Make sure the proper SCAN SOURCE and SCAN SIZE are selected before proceeding the scanning task. !It is recommended to use a higher resolution (such as 600dpi for 35mm films, or 300dpi for 120/220 films) when you proceed the film scanning task to prevent the scan images from losing the quality while you enlarge the size of the images. Scanner Utility Program The Scanner Utility Program can help you get your new scanner up and running. In addition, it contains a number of other features to help you tailor and control the scanner. Most significantly, the Scanner Utility Program checks to make sure that the scanner software is properly installed and the scanner and computer are communicating with each other. Two other features of the Scanner Utility program are the scanning lamp controls and the scanning position alignment utility. The Scanner Utility allows you to turn the scanning lamp on and off, and define an idle time for the scanning lamp to automatically turn itself off. Also, it allows you to define the exact position on the scanning glass where scanning will begin. The scanner lock was designed to hold the scanning lamp in place during shipping, but some refinement of the initial scanning position may still be necessary. Turn Lamp On/Off Verify Alignment Source Alignment Window Scan Alignment Position Genius Scanner 15 The Scanner Utility program does NOT affect the quality of scanned images. It is only used to establish a connection with the scanner. Settings that affect the scanned image (i. e. , color, size, readability, clarity, etc. ) can be found in the scanner software programs and especially the TWAIN interface. Attention Connection Status The first step to take when troubleshooting connection problems with your scanner is to check all physical connections. Make sure your scanner is plugged in and the USB cable is fit snugly into the rear of your scanner and computer. Secondly, determine the status of your USB hardware and software configuration. [. . . ] Some jurisdictions do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply. Under no circumstances are we liable for any of the following: 1. Third party claims against you for losses or damages. Loss of, or damage to, your records or data; or 3. [. . . ]