User manual GENIUS P534

[. . . ] English FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1). This device may not cause harmful interference, and (2). This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. [. . . ] Shooting will stop when the shutter button is released. NOTE In Burst mode, the flash mode will be set to OFF automatically. -29- English Auto Exposure Bracketing (AEB) In this mode, the camera automatically changes the exposure within a set range to take three shots after you press the shutter button once. AEB settings can be combined with exposure compensation settings to extend the adjustment range. Rotate the mode dial to P , pressing the 2. , , , or and turn your camera on by , then use to select [CAPTURE MODE], then press the to select [AEB], then press the button. button. To exit from the menu, press the The indicator is displayed on the monitor screen. 6. Press the shutter button to shoot. NOTE In AEB mode, the flash mode will be set to OFF automatically. Selecting the Metering Mode You can select the metering mode that sets which part of the subject to measure to determine the exposure. Rotate the mode dial to P , , or pressing the 2. Press , , and turn your camera on by button. to select the , then use [FUNCTION] menu. -30- English 3. 4. Use Use [ or to select [METERING], then press the button. button. to select the desired metering mode, then press the AVERAGE]: Averages the light metered from the entire frame, but gives greater weight to the subject matter at the center. [ SPOT]: Meters the area within the spot automatic exposure point frame at the center of the LCD monitor. To exit from the menu, press the button. Compose your subject within the focus frame. Press the shutter button to capture the image. PLAY MODE - THE BASICS Viewing Images You can display the still images you have just captured at a time. button to turn on the The last recorded image appears on the LCD monitor. -31- English 3. button. To view the previous image, press the To view the next image, press the NOTE The playback information displayed on the LCD monitor will disappear after seconds of time. If there is no image stored in the internal memory or on the memory card. [NO IMAGE] message will appear on the monitor. Magnifying Images While reviewing your images, you may enlarge a selected portion of an image. This magnification allows you to view fine details. The zoom factor displayed on the screen shows the current magnification ratio. Press the (Playback) button. The last recorded image appears on the LCD monitor. To view the previous image, press the button. [. . . ] Refer to section in this manual titled "Setting the Date and Time" for further details. * Y/M/D * D/M/Y * M/D/Y TV Sets video output system of the video equipment that you are going to connect to the camera. * PAL / NTSC LANGUAGE Sets the language that is displayed on the LCD monitor. Refer to section in this manual titled "Choosing the Screen Language" for further details. LCD BRIGHTNESS This sets the brightness of the LCD monitor. [. . . ]