User manual GENUIS REMOTE 600

[. . . ] Table of Contents Chapter 1 Introducing the Remote 600 1 Remote 600 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Unpacking the Remote 600. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 About the Remote 600 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Chapter 2 Quick start 4 Installing batteries. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Press the buttons on the touch screen to change the LCD layout. As you press the button repeatedly, the various labels for the button appear. You can also choose to leave the button blank. When the border disappears, the button is off. Press and hold button at any time to display all buttons and labels. to save the changes or to discard them. 11 ENGLISH Using preset codes This is the fastest way to program the Remote 600 but requires that your device be located in the Pre-programmed Code List that was bundled with the Remote 600. The Remote 600 comes pre-programmed with a list of preset codes. Check the supplied code list to see if your device is supported. Some newer or less common devices may not be pre-programmed and their codes must be learned using the learning function of the Remote 600. See Manually setting preset codes on page 13. 12 ENGLISH Manually setting preset codes 1. Find your device in the supplied list of preset codes. Find the digit code number from the pre-programmed code list. Use the number buttons to enter the four digit code. (Refer to the pre-programmed code list table) After you enter the last digit, a double beep sounds, confirming the code has been input. If the number isn't in the code database, the Remote 600 will beep three times continuously. Check you have entered the correct code by pressing Volume +/­, Channel +/­ or . If the code is correct, press to confirm and exit. If the code is not correct, repeat step 4. See Checking the code number on page 14 13 ENGLISH Checking the code number After automatically setting a preset code, you can find the code's number using the following procedure. This is useful if your settings are accidentally erased in the future. Press and hold the appropriate device button. While holding the device button, press and hold the "1" button. [. . . ] (See P17, P15) *Check you used the correct remote to teach the Remote 600. Some remote's frequency might be out of the learning range. You may not be able to program the Remote 600 for some devices or functions. *Check the remote is correctly aimed at the Remote 600's learning eye and you are holding the remote's button until the function is learned. [. . . ]